Routing

Friends,I have taken MPLS from 2 ISPs and they are configured in active-back up using HSRP in LAN.Now i want to loadshare traffic between both ISPs to optimize my avaialbe resource.can you suggest best method to achieve that for forward and reverse t...

Hello All,        I have  2801 and 2811 cisco routers. I need to setup a lab serial connections between the routers. Will WIC 2Ts work with the 28XX series routers? Please advise.

Can someone point me to somewhere that I can learn about VPLS? Specifically, I am trying to figure out how voice gateways/callmanagers work across a vpls link. If I need to be more specific, I can. I also would just like some general information on w...

Hi Team,I have a situation where in two switches are connected via dark fibre                       Existing Site                               New Site      (SVI for vlan 300)     |                                                 |Vlan 300----------...

Hi   I want to receive full BGP in my switch 6506 with the follow characteristics: cisco WS-C6506-E (R7000) processor (revision 1.2) with 458720K/65536K bytes of memory and Supervisor Engine 720.When I configure the session BGP in my router with me p...

                   Hi,I have a problem in that we have management on a network who's interfaces used to drop when the WAN link failed. We now have progressed onto Ethernet carrier links and we do not have the capability to monitor the link for any fa...

Hello all,We have 2 servers that share the same virtual IP address in a cluster that has an Internet presence.  These servers can be reached from the outside through our firewall.  When these servers were first set up, I configured port forwarding to...

Hello all,I have a Cisco 2801 with two DSL cards that are both routing to the internet, with NAT to the private LAN interface. I am using IP SLA and route maps to accomplish this load balancing. I have rsolved most of the issues that come with this s...

Hello Expert,I have 7606 router, got crashed today and i noticed these logs:Mar 15 09:58:01 UTC: %SYSTEM_CONTROLLER-3-MISTRAL_RESET: System Controller is reset:Normal Operation continues Mar 15 09:58:30 UTC: %CPU_MONITOR-2-NOT_RUNNING: CPU_MONITOR m...

Hi all,I have two uplinks to ISPs on one router in which they give me only default routes via BGP. I'm looking for the best way to load balance acrross both circuits with minimal config.

What is the major difference between OSPF and BGP ? Why cant v use the OSPF as EGP to ISP ( Global Internet routing ) ?