Routing

i have a switch.i created vlans 3,4,5,6 on it.it has 3 routes to reach to the core switch.i want that the vlans what i created should only be advetise on which route i want.the vlans shold not be advertise on all routes---Posted by WebUser Umair Zia

Hi there,I am completing some testing for a new project...I have some traffic coming into my ASR 1001 from another service provider.The incoming feed is 100Mb of National and International presented as two seperate VLANs.The International needs to be...

Hi Netproi ve posted the below topic with no reply,Pls Helphttps://supportforums.cisco.com/message/3567416#3567416 thanks

I have a  Cisco 2650 with a simple config as follows:version 12.3service timestamps debug datetime msecservice timestamps log datetime msecno service password-encryption!hostname MaVI_Test!boot-start-markerboot-end-marker!!no network-clock-participat...

I found a Cisco 1711 router in our storage room and I want to factory restore it so we can mess around with it or use it as a backup.I connected a console cable to it and in Hyperterminal on a Windows XP box I want to try the CTRL+BREAK sequence to c...

Hi ,We have an application which is accessed over WAN (V-Sat) and the end users are facing the session timeout problem frequently . can anyone help me in knowing , whether can we change the socket timeout value in the router, if yes how to change it....

I'm having a very curious (to me at least) issue with my c1841 configuration. I originally had it behind a Verizon Fios Actiontec router during configuration and managed to get everything set how I wanted it in a double NAT configuration so I could s...

the attached image shows what i am trying to achievei need to establish connectivity from subnets 10.30.5.X and 10.30.6.X (in VLAN1 and VLAN2 respectively) to subnet 10.11.35.Xi have a trunk port on my cisco 2960 that is connected to GiE0/0 on my Cis...

hi, I have one doubt in the static route.In my office two cisco router and both are connected in the switch.Two router one is core router and secondary router.Two routers have a wan connectivity.Router 1:LAN IP : 10.10.50.100/24WAN IP : 192.168.36.53...

Hi Friends,I am facing an issue which is very strange to me. The Goal is to find out the Interface/port  of the switch named SW-1 where the Host is connected. I have a host connected to one of the access layer switch SW-1. I am able to ping the host ...