Routing

Hi,Does Cisco 4948-E switch has the capability of supporting GRE  or its lacking this feature like 3750 ?Regards.

Hello!I have a query..When I telnet to Router I enter into config mode directly!?!?. I want to enter into privilege mode.check out da below configs.!version 12.4no service padservice timestamps debug datetime msecservice timestamps log datetime msecn...

I'm configuring a point to multipoint which is the following:interface Tunnel1 ip address 10.0.0.2 255.255.255.0 no ip redirects ip mtu 1440 ip hold-time eigrp 90 120 ip nhrp authentication <key> ip nhrp map multicast <public ip> ip nhrp network-id 1...

Hello!We run cisco 2801 connected to catalyst 3560 with Fa0/0 and to another router with Fa0/1 and sometimes (often enough- once per 2-3 weeks) we have following problem:there are much throttles on fa0/0 , users complains about bad connectivity, frag...

Hi need help to bridge dls interface and ethernernet interface so I will be able to use my public ip address on the LAN side og my router(Cisco 876). The reason is that i have another router with a public ip address on the wan side so I would like th...

Hi,I am setting up a backup site. We will have a gig-e private metro ethernet from Atlanta to Tampa, very expensive >$9000 per month so I am trying to maximize it. I want to create three vlans on the metro ethernet link, one for internet traffic, one...

Hi,I have a request to configure CoS on a cisco router that is been provisioned for an MPLS Circuit with following requirements for the WAN interface on the router.1. Commit 2048Kbps with DSCP 462. Commit 1024Kbps with DSCP 26How to I set this up on ...

Hi all,When applying my config I am getting an error of 'Cannot attach queuing-based child policy to a non-queuing based class'. Hopefully someone can take a look through this and advise if my syntax or methodology are wrong. I am assuming it is want...

Hello,I would appreciate your feedback regarding the best choice for a WAN Aggregation device.I have a total of 10 large branch connections, each WAN connection is 100Mbps (EPL) back to the DC.  We are looking at DMVPN as a solution for the cloud.It ...

Device: Cisco AIR AP1240 Switch configured as a Bridge that is connected and associates with AP's in a WLAN.Question: What is the significance of the Virtual-Dot11 Radio' s associated with the device? For example, virtual-dot11radio3.