Routing

I use "Cellular 0/0/0 gsm sim unlock 9999" but failed to unlock, error message is: Unlock CHV1 failed: SIM status = LockedStatus of CHV1 is enabled based on "show Cellular 0/0/0 security"I have confirmed that the pin number is right.Can someone pleas...

Hi all,At present I'm installing a ASA firewall between my 2811 router and the network.The router at the moment has an internal ip address of 192.9.200.253 and has NAT rules set up. The 192.9.200.254 address is that of our exchange server. My questio...

Hi,I got a Cisco 2811 with two HWICs connected to two ISP's and a WIC which is connected to internal. I have default route to both ISP's in the router configuration. How can I do load balancing so that half of my traffic go through one ISP and the re...

I have two sub nets on my cisco 2600 (ROM: System Bootstrap, Version  12.2(10r)1, RELEASE SOFTWARE (fc1)192.168.1.0/24  eth0&192.1682.0/24  eth1I have an smnp server on the .1 nw  and anything on that nw i receive traps but nothing on the .2 nw. Why ...

We have two systems running BGP fine with other neighbors but they are flapping between each other.  Connectivity between the two loopbacks is fine.Here is the log, have you seen this before?  Configs are listed below.Jun 24 16:01:32.276 EDT: BGP: 96...

Here is the scenario:Church has the following:LAN--> 3 Switches --> DSL for Data connectionPhones --> VOIP --> Switch --> T1The phone system is setup as VOIP through a T1. There data services (internet connection) is going through a DSL. The church d...

/* Style Definitions */ table.MsoNormalTable {mso-style-name:"Table Normal"; mso-tstyle-rowband-size:0; mso-tstyle-colband-size:0; mso-style-noshow:yes; mso-style-priority:99; mso-style-qformat:yes; mso-style-parent:""; mso-padding-alt:0cm 5...

Hi, I am having lot of confusion understanding STP Port roles.I know, How STP determines the root bridge, but having understanding in Root port determination, and designated/Non-designated ports.I have uploaded a topology, please see.1. In topology, ...

Hi all,             I have  facing the problem in branch site , we have branches connected to HO by lease line and the failover is ISDN . i have configured pri timeslot and dailer at HO also configured BRI and serial INT at branch site .but the probl...

Was wondering what is the maximum practical number of per VRF OSPF instances that can be created on 4948s.I read somewhere that it is unlimited, but doubt that - and worried about the CPU load - we have a 4948 and without anything major on it the CPU...

Does anyone know if the ip precendence command is available in Cisco IOS Software, C2600 Software (C2600-TELCO-M), Version 12.4(19b), RELEASE SOFTWARE (fc1).  c2600-telco-mz.124-19b.bin"Thank you

when issuing sh ip bgp neigh <IP> i am getting header sync problems and the peering stays IDLE - see below for outputAny help is appreciated before logging a TAC case :-) RP/0/RP1/CPU0:ND-NEO-RCRS1-ISP-DMZ-R1C11#sh ip bgp neig 192.168.32.18Tue Jun 2...

hi! i'm subscibing for wan connection for connection between branch sites. there are 2 types of connection recommended, optical and adsl. Optical to connect to the internet and adsl for vpn tunnelling between sites. What's the different between optic...