Routing

HiToday I'm trying to configure this router, and I have a problem configuring the firewall rules by SDM or ES. When I use the basic/expert wizard to configure it, when I finish and send all the commands to the router, say that have an error in a clas...

I'm trying to setup a test environment with 2 2650XM routers that have 1 NM-1T3/E3 card each. I have a 9ft coax cable connecting the 2 routers together. Is this setup possible to configure? My configs are below and the AL & EN LED are lit. How ca...

hi, hi create different vlan 10,20, 30 ,40,50,60.they r not communicate each other vlan with vlan 10.now i want to access internet each of vlan.note:swith can capable to ping my dnsplease give me some solution

I am looking for days already why this config does not work. I even don't get any debug message out of it. The problem is that it seems that the router passes all traffic, regarding access-lists or whatever. It's just like if both Ethrnet ports on th...

I need to position Router with firewall and VPN capabilities for 80 users.Which model of 1841 do I propose?

All,I have a 2800 series router that boots to rommon mode only after being left off of power for a while. I left it off and disconnected from power last night, and I came in this morning to find out it booted in rommon again. I can change the config ...

Looking for a white paper or SRND document that categorizes router commands into those that are process switched and those that can be fast switched or cef.Main concern is with a router that is running as a firewall and doing NAT/PAT and IP Inspect. ...

Hello,wondering if anyone can help ?.trying to add the following command to my E1 controller on the above router and I get the following error messageCHPFXW01(config-controller)# pri-group timeslots 1-31 service mgcp% Not enough DSP resources availab...

I have a 1861 router I am trying to put an advancedipservicesk9 image on and I am see the error shown in the message:error: Fille too large for TFTP protocolI have not seen this before and I have put this image on one of the other 1861 routers with n...

Hello,I'm trying to get different options on a way to bridge two networks in different sites. Basically I have two locations that need to extend VLAN(s) with about 15ms latency between them.1. My questions what are the options?2. Does anyone know of ...

The topology consists routers and layer 3 switches. These are 2 remote locations with primary connections via MPLS and a backup/"primary between sites" via high-bandwidth radio.There are obviously several subnets here, and everything on the LAN side ...

Hi,Router 2851 getting following error and crashing%SYS-2-INTSCHED: 'suspend' at level 3 -Process= "Kron CLI Process",

Hi Guys,I have just a little exposure to the 7xxx platform of routers, and i need some help with a migration upcoming. My question is, will the following list of Cards install/ fit and work correctly in a 7304 Router?PA-FE-TXPA-GE=PA-2FE-TThanks Step...

I am upgrading the IOS on my 7606 to SFX15. I am running 2 sup720-3B's. One is active one is standby. If I load the the new ios onth disk1 on the active sup and reboot will the standby automatically update also or si there something I have to do.