Routing

Dear sir,i have cisco 2800 router i want to enable tenet acceses and i want to give permission to administrator accese and userleval acceses .how can i configure the router.srini

guys just a quick question when we configure FR on wan router (site 1 and 2) and FR is ocnfigure don physical interfaces (no arp) so we have to mention neibour command on one router or both????? or one would be enough.....as i have seen configs that ...

I have a Cat6509 with a MFSC2 running c6msfc2-jk2o3sv-mz.121-26.E1.bin and it has a bootldr image c6msfc2-boot-mz.121-26.E1.bin.I want to upgrade this IOS to support QoS on MLPPP links. I have found an image that will work with the current size of m...

Looking at purchasing/deploying 2811 WAAS routers on the WAN. It appears that a dedicated WAE in manager mode would be needed if management is desired. Is the management WAE really necessary. Configuration can be completely done via the CLI, at least...

Can anyone guide me what type of cable will be required for 4 port clear channel T1/E1 HWIC HWIC-4T1/E1?I see this card has RJ-48 connector,,, not sure of cable type!!!!

Does anyone know how to best find out what "unknown protocol drops" are being dropped on a router ethernet interface. Initial packet capturing is not providing a lot in insight...so far.Thanks,Brandon

Dear allI have three branches and one HQ.I have leased line for connectivity betweem HQ and remote sites.I want to use dialup for backup incase of primary link failture.how can I configure my router to start dial up automatically when Primary link fa...

I am going to update a 1721 router from 12.3 12.4(16b) and their is a command in the frame realy Virtual-Template that gets dropped I think it doesn't matter but want to make sure. the command is the "ppp ipcp route default" below is the Virtual Tem...

i am getting packets from the given source and destination. Can some one tell me how to decode it so that i can get the list of ip addresses.source=0.27.129.1 destination=0.50.8.0regardsshivlu

Hi all....I need to accomodate for 4 ADSL line bonded together and then one FastEthernet output to the rest of the LAN.Its a small to medium sized network so the router does not need to be high spec i wouldn't have thought.Any recommendations of cisc...

I need to put 4 Csu/dsu's into a 2621xm. I already have two WIC-1DSU-T1 in the unit. How do I add two more WIC-1DSU-T1 to this unit using the expansion slot.Thanks

Hello Gents,Just a question about load balancing over E1 links: I've got two routers linked together by 3 E1 links.2 * E1 belong to TELCO X which crash a lot and not reliable at all (lot of errors on the links)1 * E1 belong to TELCO Y which provides ...