Routing

Dear ALLIf i am using CDP on my Routers iam not able to discover any CDP neighbours and if i am using CDP on switches i am able to discover all LAN DevicesCould some body help meOut put of CDP on my ROUTERS is below, #sh cdpGlobal CDP information:...

I'm currently using the standard setup for a PPPoFR link:interface Serial0/0 no ip address encapsulation frame-relay IETF no fair-queue frame-relay traffic-shaping frame-relay interface-dlci 50 ppp Virtual-Template1 class 1638!interface Virtual-Temp...

hiI've recently installed a cisco 2811 with a VWIC2-2MFT-T1/E1 card.BT is providing me:Electrical Interface: G.703Physical Connector: BNC 75 ohm unbalancedI have already ordered a CAB-ADPT-75-120 adaptor cable. Now my question is:what cable do I need...

Hi All,I've run into a rather odd problem connecting to a dry loop AT&T ADSL circuit. The CP router is a 2651XM running 12.4.12c Enterprise IOS that currently handles the company T1, I added a DSL WIC for outbound traffic, the ADSL circuit came up wi...

i applied rate-limit input cmd on a 2 Mbps Serial Interface so as to restrict the customer traffic to 128 Kbps.attached is the int config and the ping response when i tried to ping the other end of this serial int.i got a lot of drops.i tried all the...

Hey, folks:Question: I have an ATM to FR hub and spoke. Im running OSPF. Why use point-to-multipoint subinterfaces? In what situation would one do that? What are the advantages of doing that over creating point-to-point subinterfaces on the hub and s...

Hi guys,Need some advise from you.My site have a MPLS connection with a CoS service-policy output configure on it. The problem is, my link keep on congested by incoming default traffic! How do I stop this? My business class CoS is base on IP range, d...

Hello All,I am in the process of designing an Extranet and am trying to figure out what are the best practices for such a design in general.In particular is there any standard practice regarding allowing public ip addressing space into the Campus Cor...

Hi,I am trying to build up the given topology by 1760 router and VWIC-1MFT card for voice and data communication. Please give me some configuration level guideline. If possible, Please let me know the required IOS version and DSP module.Here the topo...

Hi, My question is with regards to the usage of the ip accouting command. The Cisco doc says that 'Only transit IP traffic is measured and only on an outbound basis ' ....[1] When I do the below command, it looks like the 'rx' is high but if I do en...

our head engineer is implimenting MPLS across our network..As I am totally unfamiliar with it..Is this much more difficult to support? Im trying to learn about it and basically..they are packets that are tagged..and it is easier to impliment QoS...is...

HiCan anyone send me good documents of Datacenter design including configuration. I am have some doubt in Access to distribution setup..-V

Hi Everyone, I'm trying to configure a 1841 Router to do a translate between one central running X.25 (EWSD) and a client running TCP/IP. The PVCs between the central and the router are ok, but when i try to telnet the central i don't receive and res...

Can anyone make suggestion on which kit to buy from ciscokits.com? I've read product descriptions and they say "this contains the latest..." or something of the sort, but there aren't any dates as to when this information was posted.