Routing

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Labels

Forum Posts

Dear Experts,Working in my testing environment I have connected two IP GRE tunnels. Tunnel 1 - Tunnel between two 3550 IOS 12.1(22). Tunnel 2 - Tunnel between two 2800 IOS 12.4(4a). While working with both tunnels I have noticed few major differences...

Resolved! BGP

Hi,Where can I get the detailed documents and some sample configs on BGP.

kvnmurthy by Level 1
  • 466 Views
  • 1 replies
  • 0 Helpful votes

Hello! I have a Cisco 827 that I it want to use for my connection to Internet in house.I have tried several configurations but I have not managed to connect to Internet.I don?t have static ip, my ip is dynamic.This is my configuration:version 12.2no ...

Can someone direct me to documentation on what the route distinguisher x:y means and route-target commands...thx

whanson by Level 2
  • 742 Views
  • 4 replies
  • 0 Helpful votes

I know I've got a whacked out config, but there has to be a way to make everything work! My problem is computers on the 172.16.0.0 subnet cannot reach the internet. My requests either time out or I get destination host unreachable back from the rou...

I'm familiar, when working on router IOS, and modifying the ACL on the WAN, the ACL must be removed from the WAN (no ip access-croup...).When working on a PIX via SSH, I'm assuming some similar technique is needed.Is there some documentation on how t...

Hello, We have a new T1 circuit that was tested out by the engineer as working. The Telco sent us an adtran router, but we are going to use a cisco router instead. We cannot get it to come up for more than a second. They are saying the circuit it ...

t.khan by Level 1
  • 4690 Views
  • 3 replies
  • 0 Helpful votes

Resolved! PPPoA Subscriber

Hi!My question is:How many subscriber I could handle in my router Cisco 7206 using PPP over ATM protocolo? Best Regards, Ing. Darwin Santana

dlsy by Level 1
  • 994 Views
  • 3 replies
  • 0 Helpful votes

I have a router acting as an Internet gateway. I have a server on the private network that I want to be setup as an FTP server. I have an available public IP address to dedicate to this. I am having a problem getting it to work.I have a nat outside s...

jweldin by Level 1
  • 726 Views
  • 3 replies
  • 0 Helpful votes

Can anyone tell me what the LED is to the left of the power switch on a Cisco 3660 router is? And what it means when it is orange?Thanks,Chris

Hi Sir,I have installed an NM-2CE1T1-PRI network module on a Cisco 3845 ISR, connected to an E1 line using cable CAB-E1-RJ45BNC.The configuration is as follows:!card type e1 1!controller E1 1/0 channel-group 0 unframed!interface Serial1/0:0 ip addres...