Routing

We have just upgraded a Remote site that had a Frame T1 1544/512 to the Hub Site to a Frame DS3 with a port speed of 45M and a 6M of CIR.My initial thought was that they will be atleast 10x faster on DS3 but they are only 4x faster. Question is, is i...

I have 2 MPLS circuits. Second I want to use as backup.Is there any way of making second wan link as backup even if the first link is up but has high latency, on first link I get 200ms response time, but sometimes in case of service provider problem ...

Hello all,I have some 871w routers, with advanced IP services IOS, that are used to connect some branch offices to a main office. The routers connect to the Internet through a PPPoE adsl connection. A gre/ipsec tunnel connects each branch to the main...

Can someone recommend a router platform that has enough memory to handle BGP routing tables and has switching capabilities.

Hi.I am facing a problem some time my differnet sublents on two router did not ping each other . i ahve have simple sataic routes on my router'si want to know about the Arp ???? How much time remain enty int arp table. And how much its can save entr...

Is you have a DR site with two routers at the site (no HSRP), the ethernet interfaces of both routers on the same subnet. Each router has a different path to the Main site, path A and path B, no routing protocol on the routers.Is it possible to confi...

please give me sample config how to configure dual WAN (2 ISP) for Cisco 1811 ISR router, with load sharing and failover.. and what if I add VPN failover with 3 sites using IPSEC.I appreciate your big help.thank you very much...

Dear All,I have to take 2 internet connections from 2 different ISPs so that i have to run BGP in my network.But i dont have my own AS number.Is it possible to config BGP with Private AS.Will fallback work in this case.TIARegardsSAM

my one of client having problem in pri ,in this pri configured 30 chennal.only three connection can able to connect.if more then three channel tri to connect my pri interface goes down and few seconds comes up.i changed my modem i checked pri line e...

I have configured Cisco 805 router as Internet gateway and it works fine without any access-lists. With following access-lists there is no Internet connection:access-list 101 permit tcp any 192.168.1.0 0.0.0.255 establishedaccess-list 101 deny ip an...

Hi All,Need to know how can SNA traffic be prioritized??Thanks.

hello to all,how can i configure DHCP server as well as client in my cisco routes rack and i also want to enable the SSH?and what is difference between loadbalancing and loadsharing? what should i use in server farm loadbalancing or loadsharing?dport...

We have a T3 circuit between London & NY which there there appears to be a lot of latency and TCP overhead, we have been looking at the HP Wan Accelator and Riverbed. Please can you post your comments on this solution many thanks

I have T1 connection. 17 channels for data. The remaining 7 for voice. I have a Paradyne external CSU at each end. What kind of Cisco internal module could I use to replace these Paradyne CSUs and do have example of the configuration. I am pretty sur...