Routing

Upper management requested traffic prioritization on UK to US link. What I found in attempting to "custom-queue" was that, It must be enabled on the interface globally...(not possible on the sub-interface). It can't be used with Frame-relay traffic-s...

HiI have 2 ISP connect ,I want users who uses mail they uses ISP1 and who uses www traffic they uses ISP2. brief description in attachment. pls any any solve this problem how can i differnt traffic flows between ISP1 and ISP2.thanks biplobbiplobk2000...

HiI tried to make space on the MSFC2 bootflash by squeezing the bootflash after a delete of the boothelper image. The catalyst llocked up and now won't boot. Is there a way out?The recommended cisco method does not seem to resolve it I get a software...

Hi,I have a Cisco 2610 with a BRI card (4 ports). We have on two seperate locations other Cisco routers which dial-in on this router, with a password and username specified in the Cisco 2600.LOC A (10.130.20.245)HQ (10.10.20.245)LOC B (10.16...

We have Internet peering with multiple ISPs at Asia Pacific, Europe, US, UK , Honkong. From these Internet peerings, we are receiving all the internet routes. Is there any way we can filter prefixes based on geography.How we can find out what prefix ...

Dear all,How can I check the backplane capacity of 3745/3845?Regards,Raymond

Hi,we have a 3745 router with 2 E1 links going to one remote Multiplexer. Those links are made redundant by setting the same IP address on the other side (on both E1 interfaces) as well as on the 3745 side. It works very nicely.However, I wanted to s...

Dear all,how to read show tech support output to find problems in routerThanks & RegardsSAM

Hi,I am using Cisco 7200 router as the BRAS which allow pppoe termination. How do I make sure the username: xxxx can only be used to login one time at a time! Meaning, to say, once somebody already login to my system using this username, then, the se...