Has Cisco made any progress in updating this feature request to support the full Root-Intermediate CA validation?
Forum Posts
Hi all, i have topologi forti(as a router internet &mpls) - Core switch - Palo-Alto ( FW server Farm) Connection core to forti using ip p2p & static default route 0.0.0.0/0 for access internet & access MPLS, Connection core to Palo-Alto using ip p2p ...
Hello Dears,In our environment, we have a Cisco 2911 Router (IOS). We are now planning to replace it with a Cisco C8200L Router (IOS-XE). In the old router, we have BVI implemented. Since this feature is called BDI in IOS-XE, I have migrated the conf...
Hello,I have in my enterprise many dynamic routing protocols, within VRF and without VRF, like , EIGRP, OSPF, eBGP, ISIS and static routing.Im good with those and dont need to do any kind of upgrade.I have MPLS L2 VPN/MPLS L3 VPN , MPLS TE and IP Rou...
Resolved! Routing External IP via VPN Tunnels
I hope someone can help me find an answer to this scenario. We have another organization with which we have a site-to-site tunnel. This tunnel is located at our home office. Our remote sites have site-to-site tunnels to the home office. The other org...
I see that the lower ASR100x-X routers are already EOL. For the ASR1006-X and ASR1009-X there are no EOL dates out. Does anybody have any information on the expected lifespan of these components?
I am simulating a simple network technology with IOU L3 images and observe a strange behavior with image version 17.15.1The network consists of 4 routers, One of them is named a "SourcePC" (bottom of diagram) - a router from which I do an ICMP ping (...
I'm curious what the difference is between the following log entries: %IOSXE_SPA-6-UPDOWN: Interface TenGigabitEthernet0/3/0, link down due to remote fault%IOSXE_SPA-6-UPDOWN: Interface TenGigabitEthernet0/3/0, link down due to local fault What would...
Hello all,I'm having trouble getting my BGP peers to show up in the VPNv4 BGP peering output.For example, if I have a very simple topology of 2 routers directly connected, and I run simple BGP between them using the IP on the directly connected link ...
Hi I am currently using my SG350XG but am going to move over to my Nexus 9K C93120TX. On my SG, I have these settings for ACL/PBR/vlan8 which works; ip access-list extended SL deny ip 192.168.0.0 0.0.255.255 192.168.0.0 0.0.255.255 permit ip 192.168....
hi can you tell me what is the problem i cant ping pc c to the serverthank you
Hi Teamwhat would be the possible cause of this error ? & solution steps
Hi, we have new purchased catalyst 8300 router with network-advantage and dan-advantage(mandatory). For initial setup, do we need to configure dns license under exec mode. We are not using DNA center to manage the devices. Currently I just run the fo...
I am recently retired from IT, with NO routing experience, so don't be surprised if I say something anything that is incorrect. I'm working on a home lab to isolate my experimentation from the rest of the house and I have a problem - my Cisco 4351 ha...
Hello,I'm reading datasheet for c9300 series switches and I don't know if I understand correctly the meaning of "direct" and "indirect" routes under performance specifications (eq. 32,000 (24,000 direct routes and 8000 indirect routes)).Are direct ro...
