How to disable RIP and telnet on firepower 1140

[MrBeginner]

Hi,

I would like to disable RIP and Telnet on firepower 1140 . But i don't know how to check RIP/telnet is disable .

let me know how disable RIP and Telnet on firepower and how to show they are disabled ?

[Kasun Bandara]

Hi,

use below document to configure/change relevant services.

https://www.cisco.com/c/en/us/td/docs/security/firepower/fxos/fxos231/web-guide/b_GUI_FXOS_ConfigGuide_231/platform_settings.html#task_14A3611502A44A338EF0CCF15F3FBB58

RIP is disabled unless you configure RIP parameters.

Rate this and mark as answer if this solved your concern

[balaji.bandi]

Until you specifically enable RIP, its not enable by default.

You can check RIP Enabled or disabled here :

telnet

FTD does not support Telnet connections. Use SSH instead of Telnet to access the device CLI.

you can configure as below :

https://www.cisco.com/c/en/us/support/docs/security/firepower-ngfw/200701-Configuration-of-Management-access-to-FT.html

[MrBeginner]

Hi @balaji.bandi and @Kasun Bandara ,

Sorry for misunderstanding. I forgot to mention FDM . I am not using FMC.

[Kasun Bandara · Accepted solution]

Hi, @MrBeginner 

FTD by default not support telnet as per below guide. and as mentioned earlier , RIP is not working until you specifically enable it.

https://www.cisco.com/c/en/us/td/docs/security/firepower/623/fdm/fptd-fdm-config-guide-623/fptd-fdm-advanced.html

rate this and mark as answer if this solved your concern

[Giuseppe Larosa · Accepted solution]

Hello @MrBeginner ,

I have a pair of FP1140 in HA using FDM

the GUI has no option to configure RIP that you can configure using FlexConfig   ( access to ASA CLI) I'm in 6.6.4

So RIP should be disabled.

telnet connection should not be supported as noted

Hope to help

Giuseppe