Internet Access
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
10-16-2013 02:01 AM - edited 03-04-2019 09:19 PM
I am trying to setup my lab so that I can have internet access. I am having a little problem configuring my router to allow it.
Here is what I have going on:
Dlink Router connected to the Internet Modem
Cisco 2821 connect to LAN port on back of Dlink Router
Dlink
192.168.1.1
Cisco 2821
Gigabit ethernet 0/0 192.168.1.119 ----> connection to Dlink Router
Gigabit ethernet 0/1 192.168.0.119 ---> connection to Lab Switch
interface GigabitEthernet0/0
ip address 192.168.1.119 255.255.255.0
duplex auto
speed auto
!
interface GigabitEthernet0/1
ip address 192.168.0.119 255.255.255.0
duplex auto
speed auto
!
!
ip nat source list 101 interface GigabitEthernet0/1 overload
ip route 0.0.0.0 0.0.0.0 192.168.1.1
!
access-list 101 permit ip any any
What do I have wrong?
- Labels:
-
Other Routing
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
10-16-2013 03:07 AM
Hi,
Few things, could you try:
ip nat inside source list 10 interface GigabitEthernet0/0 overload
access-list 10 permit 192.168.1.0 0.0.0.255
Sent from Cisco Technical Support iPhone App
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
10-16-2013 03:21 AM
Got, after staring it for a few more moments I figured it out. Had my NAT and DNS messed up.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
10-16-2013 04:44 AM
I am glad that you figured it out. Thank you for posting back to the forum to tell us that it is solved and what the problem was.
HTH
Rick
Rick
