At present the Cisco document says the below features are not supported in IOS XE What is the difference between Express service vs onRamp service ?
Forum Posts
HiPlease help me in understanding the below points.1) For a network setup for nearly 40 ~ 45 branches what is the recommended practice for placement of the below components. a) vBond - Cloud or On premises b) vManage - Cloud or On premises c) vSma...
I have the below query on security on SD-WANTo achieve local breakout for O365 traffic it is required to have default route in vEdge devices so that any traffic destined to O365 will go via local internet.Since default route is open from branch side ...
I have the below queries regarding achieving local internet breakout for O365 traffic via SD-WAN using DPIMy understanding for this as below.1) SD-WAN should have default route to Internet (VPN0)2) NAT should be enabled.3) DPI should be enabled for O...
I wonder what happens if for instance someone will configure vEdge mngmt port in VPN512 as shutdown? If the device is in a "vManaged mode" how can it be unlocked? Is there any mechanism preventing the devices to be totally lost to controllers? Thanks...
After building Controller Profile and adding vEdge (ISR4331)device to a PnP portal I downloaded provisioning file (vEdge devices). When successfully uploaded provisioning file (no errors) to vManage there are no visible vEdge devices. I receive the...
I have the below routes in my L3 device which is connected behind Cisco SD-WAN router (DC side)The network 192.168.150.0 belongs to the branch network which is learnt as OMP in Cisco SD-WAN router.But on the L3 switch device behind the SD-WAN router ...
HI all, I'm preparing possible design for SD-WAN for our comapny. Having major question about possible coexistance of cEdge SD-WAN router (ISR 4K router) and internet CE router. It **bleep** possible? To give more info about our setup, we do not ha...
Hello, I am trying to set up an image download on a ENCS device : ENCS5412/K9; ENCS54_2.6.071220181123 I am trying to download an image from a server via https.The command : system file-download file { source http://myfileserver.lab/myfile.bin } wor...
Hi, with viptela architecture, do we need to deploy firewall at the branch or does vEdge comes with firewall functionality?
Hi, im trying to do a simple routing over two vedges, this seems to do not work on version 18.4.0, as i tested it the same config on a Cisco lab running 17.1.1 and working fine. Its a simple routing of a network via 2 vedges and 1 normal router, to...
We are gearing up the whole SDWAN thing and I am being told the dual DIA circuits need to terminate at the sdwan edge device, but I need to keep my firewalls behind this device for compliance reasons. Well I have always done the NAT at the ASA, so ho...
Hi, im facing the next issue: We have two branch with 1 mpls + 1 internet link. Primary branch is publushing default route via BGP to the MPLS link, secondary branch is doing the same but with as-prepend on the default route. When primary branc...
Got a two part question today... 1. I have seen lots of mention of VPN512 (management VPN) in documentation and presentations, but I have yet to see a practical use demonstrated. Does anyone have thoughts on best practice to use this / are people a...
Team,Which Cisco 4xxx ISR's are supporting the Viptella code? Is the code supported even on the ASR series?Anyone aware about a compatibility guide to move to the new Viptella code? Thanks!!N.
