We're pleased to announce that AnyConnect is macOS High Sierra (10.13) compatible.
Our recommended version for High Sierra is 4.5MR2 (4.5.02033), available today 9/25/17. This version includes additional guidance to ensure that the AnyConnect Kernel Extension (KEXT) is properly approved by the end user. This is a new requirement in High Sierra.
4.4MR4 and 4.5MR1 have also been tested for High Sierra compatibility, but will provide no further guidance to the end user (beyond the single OS prompt) that manual steps are required to provide full AnyConnect capabilities. Additionally, with these older (compatible) AnyConnect releases, a reboot may be required after manually approving the AnyConnect extension to continue to run. This step is not required with 4.5MR2.
Note: Customers using Host Scan must be running version 4.3.5038 or later of the module in order to detect the presence of the macOS 10.13 firewall.
We will continue to look at any way we can optimize this experience in subsequent maintenance releases.
hi, Does anybody knows what is the default WebUI (firepower chassis manager) idle timeout?Where i could change it? For FP7/8k series you could do that in system policy/ platform settings, but i cant see this option for FTD.
Hello.I have ASA5506-X with FTD image installed. I connected it to my smart account and now activate 3DES license (PAKs or Tokens->Get Licenses->Crypto,IPSec->Cisco ASA 3DES/AES License->[enter sn]->next).Then: Add new PAK->[fill PAK, pi...
A network contains a remote tunnel interface and firewalls in the network path of each router. An attempt to ping the IP address of the remote tunnel interface fails. Which connections should be allowed through the firewalls?A. IP protocol 50B. TCP port 1...
Hi Guys We've got Stealthwatch Enterprise up and running and so far I have to say I'm really liking it but we are having some issues with flow matching which results in a lot of traffic being picked up as being a new flow instead of being part of nor...