We're pleased to announce that AnyConnect is macOS High Sierra (10.13) compatible.
Our recommended version for High Sierra is 4.5MR2 (4.5.02033), available today 9/25/17. This version includes additional guidance to ensure that the AnyConnect Kernel Extension (KEXT) is properly approved by the end user. This is a new requirement in High Sierra.
4.4MR4 and 4.5MR1 have also been tested for High Sierra compatibility, but will provide no further guidance to the end user (beyond the single OS prompt) that manual steps are required to provide full AnyConnect capabilities. Additionally, with these older (compatible) AnyConnect releases, a reboot may be required after manually approving the AnyConnect extension to continue to run. This step is not required with 4.5MR2.
Note: Customers using Host Scan must be running version 4.3.5038 or later of the module in order to detect the presence of the macOS 10.13 firewall.
We will continue to look at any way we can optimize this experience in subsequent maintenance releases.
Hi guys,I have a RV130W. I am trying to get my Mac to VPN to it. PPTP seemed to work using Shimo for a while until the upgrade to Catalina. Now I need a new option coz PPTP on Shimo for Catalina isn't supported. Is Cisco IPSec is different than regul...
Hello,I am no able to add the device IP address option when adding a new Network Device. I cannot see the option to add the IP address.Steps:Administration > Network Resources > Network Devices > Add I used to have that option before.Any sug...
As title describe, i would like ask is it possible traffic passthry multiple IPSec seti-to-site VPN tunnel, where as control the traffic using routing.
Attached the network topology as refernce.
Or is there any other workaround to ach...
Hi All As title describe, i would like ask is it possible traffic passthry multiple IPSec seti-to-site VPN tunnel, where as control the traffic using routing. Attached the network topology as refernce. Or is there any other workaround to ac...