Server Networking

I have a question regarding load balance/redundant configuration. The topology of the network are two redundant links (1 Gig each). One end of the links are two Nortel Passport switches; the other end of the links are two Cisco Catalyst 6509 switches...

i need help on establish x25 communication between inter-vlan into x25 host.(X25 Cloud)--router--Vlan2--Host1--Vlan3--Host2When configure cmns enable at int ethernet (router), host1 is working fine but Host2 is not working..Pls help me on configuring...

when a show version command is issued router displays many parameters one is memory it is displayed in smoe different way like say for 2048 K / 1024 K what is the difference between these two ?

We have a 6509 running in Native IOS that has 2gb port channels connecting to our 7 access layer switches. About a week ago we were working with Remote span vlans and added a remote span from the 6509 to our other core (6513) which is connected via ...

I would like to get some input as to the best switch to use at the access layer. I am considering both the 6500 with a Supervisor 32 and the 4500 with a Supervisor 5. I am using the Sup 720 in the data center so staying with a single platform is appe...

Part # PWR-3825-AC Please send snapshot to dell94583@yahoo.com if forum does not allow so. TIA,

Hi everyone,Just cuirious if anyone has setup something similar before. We have a clustered setup for customers, where we setup a virtual server on the 6509 which then load balances across multiple servers.What I want to do is somehow track the serve...

We have a Cisco 7500 with one CIP module, connecting via Channel 1/2 to an IBM Mainframe using APPN.We have one TN3270 server running in the router (7500). Question:Is it possible to have several instances of TN3270 servers running in the same router...

I am implementing 2 6509 with sup 720b/pfc3/msfc3. Seeing that cisco is going to IOS modularity for the 6500s, what is the better deployement for a enterprise core design. Should hybrid or native mode be deployed?Any thoughts or recommendations would...

Hello:I am working a project where there is a requirement to have a primary server and a secondary for application failover. The requirements dictate that the servers must be geographically separate at separate data centers but yet on the same IP su...

Hello Forumwe are trying to establish a connection between 2 PUs and the M/F. The two PUs are actually two controllers inside an IBM 400. The IBM 400 is connected to a cisco with an x25 line. The M/F is connected to the ethernet side of the cisco.So ...

I am trying to establishe a conection between 3746 on one side, and OSA on the other side of the wan. The status in the routers is the following:router#sh dl ci deIndex local addr(lsap) remote addr(dsap) state uptime637534720 ...

Hi,One of my customer needs a Disaster Recovery Solution for following scenario:- Primary Data Center is at SITE A, and the Backup Data Center is at SITE B. - Clients are located at multiple other branch offices.- Interconnectivity b/w all sites is o...

Hi,Pls refer the attached topology.Need clarity/advice on the listed points in terms of catalyst switch and cisco router configuration.Router used will be cisco 3800 with BGP running on it.Data flow:- servers will be hosted in datacenter.Service prov...