Server Networking

Hi all,i need to know if it is possible to change the destination SAP address in a DLSw connection. I mean the following: from the other peer of a DLSw connection I receive a request for a destination MAC and a destination SAP out in my token ring in...

Hello,I have some questions regarding the TCP sessions managed by DLSW. A customer is using DLSW with priority between two routers.He's also using sap-priority-list.The high priority telnet session (2065) isn't used by SNA traffic regarding the sap-p...

Hello, Having TCP session problem between 2 routers (DLSW), I get a "show tcp". For the high TCP session (port 2065, DLSW with prioritization) I have some "GiveUp" started timer. Can someone explain me what is this timer for ? Stand-alone TCP connect...

I have a HP-UX server with 4 GigE NICs. I would like to have them span 2 switches, and have them all aggregated together into a single logical link. Can I span switches like this, and if not, why? Thanks in advance.

Hi,I am running IP CEF on a 2621XM router. The router has 2 x 960Kbps lines connecting to a data center. The line utilization never exceeds 80% utilization, but I keep on getting WAN_BUSY on the data center router (7513 with CIP). The 7513 runs IOS 1...

I am looking for some helpful insight on what you might do in this situation. I have a very good idea on what I want to do, BUT I am looking for different ideas. I am looking for the different ways of doing the same thing. Plus the recommended way ...

Hello everyone,I am involved on the developement of an analysis tool that requires knowledge on FST (Fast Sequenced Transport) protocol.My best guess is that FST is propietary, that is why I could not find anything on the net.But being propietary doe...

Hi..Is it possible to mirror a WAN interface on the router.Means if the packets are coming on one serial interface can go to another mirrored serial interface at the same time. i need to analyze A WAN link with out putting the analyzer in between the...

Hi Everyone, I need some help from you guys hope that you guys can help me with this or where can i find information about it. I would like to know what is the offical documentation of a brand new cisco switch. Thanks a lot in advance.

hellowe are trying to integrate some legacy sna hoststo switching enviromnent.we are faced to a strange symptom when legacy hostsare connected to 2950 switch no traffic sna pass thruwe checked vlan,ports ,STP, but didnt found any hintsremoving 2950 f...

Suppose a location has 500 access level switches say 6509s. And, it is required to upgrade the code on these switches.What is the best way to do this task?TIA

I am tasked with finding cheaper broadband solutions for connecting remote facilities back to corporate. I need to set up IPSEC tunnels from the remote to corporate that allow me to not have to change my current private addressing. This I believe I s...

Hi all,i have the following setup.Ethernet1 - (Router-Bridge) -TR1 ---Serial---TR2now i change my setup toEthernet1 - (Router-Bridge) -TR1 ---Serial---TR2 - (Router-Bridge) - Ethernet2-my problem is that the port of the link to the Ethernet2 goes to ...