Hi all,I need a help from you all, i just discovered that Nexus switches does not support dhcp server feature. I however plugged in a dhcp server on a access port say in vlan 10 on the interface vlans on the nexus switch configure dhcp relay to the d...
HI,I have one Nexus 7K switch in that Module N7K-F248XP-25 showing powerdown. Please find the details for below:-Mod Ports Module-Type Model Status--- ----- ----------------------------------- ----------------...
Hi all, i am just laying around with two nexus switches and testing some features. I config vPC between the two switches and also did a member port to a catalyst switch. Everythg works fine. I decided to do inter-vlan routing.I connected a catalyst s...
Hi all,I have a vPC domain topology between two N9K switches. I want to connect a router to it, what is the best pratice of connecting a router to a VPC Topology.Should i each router link to the switch as routed port or do a portchannel on the router...
Hi Does anybody have information on future support for VM-FEX in vSphere 6 ?The current drivers package for blades ucs-bxxx-drivers.2.2.5.iso "\VMware\VM-FEX\Cisco\VIC\ESXi_6.0\ " just has a readme file that says: NOT supported.The divers package fo...
We are in the process of a ESXi refresh and would like to bring up the new hosts on a new 1000V HA pair. This would allow the new hosts to be installed from scratch with a minimum of 5.5 instead of having to step them from 5.1 to 5.5. Is it possibl...
Hi all, Could anyone advise if there is a document stating the MTBF value for the Cisco FEX C2248 Actually I need to find out the MTBF value for each of the components, but unfortunately I can not find anything so far.N2K-C2248TP-1GEN2K-C2248-FANN22...
Hi,I'm seeing some strange behavior with a Nexus 5k 5.1(3)N1(1) where one config line is always missing from the startup-config despite it being in the running-config.I have several 5k devices, all running the same code, all exhibiting the same issue...
I am looking for a configuration guide for OTV using the ASR platform where the ASR is not the main routing platform. I would like to deploy OTV between two sites which already have L3 connectivity. The ASRs have been purchased to provide L2 between ...
Hallo everyone, I am waiting our new Nexus(2x5548UP).We have 3 ESXi. we will connect every ESX with both of the Nexus Switches using 2x1GB uplinks, which means we will have 2 connections to the first and 2 connections to the second Switch.I am thinki...
Hi All,I need your hel. Im new to nexus switch. I configure a router to have a port channel pair to two vPC peers.running sh vpc on the two vPC peers shows the port channel, vPC is fine and display the portchannel to the router is fine, but if i run...
Hello,I have two nexus 5000 setup with a vpc peer link. I also have an cisco c240 m3 server with a vic-1225 card that will be running esx 5.1. I also have some 4 2248 fabric extenders. I have been searching for some best practice information on how t...
Hello All!!I cannot see VEM module in VSM after installation.I checked the connectivity in the same vlan with ESX host and VSM.Both are able to ping each other.Please have below my card info on ESX.~ # vemcmd show cardCard UUID type 2: 5f8a22e2-2d09...
Hi Team We are getting high noise from particular chassis,all the fans running high rpm(speed 9300) but we received minor alert. Can anyone please suggest the remediation . Thanks in Advance