Software-Defined Access (SD-Access)

I have two border nodes ( c9500 ) version 16.09.05 connected to EDGE node ( c9400 ) version 17.03.01 i start a LAN automation and i create a fabric i make the connection with two fusion router my problem is the lik between two border not change to L3...

HiMy customer has asked for the bundle license R-ISE-10VM-K9= however the part codes is EOL and R-ISE-VMM-K9= given as the replacement What I don't understand is do I need to quote the customer 10 x R-ISE-VMM-K9=? Thanks  

Hey guys, is there a way to combine SD-Access and ACI in general?Currently we have our Campus-Network set up with Catalyst Switches and our Datacenter with Nexus Switches.I'm looking for a way to combine the two SDN solutions and operate them paralle...

.

Dears, I have border and control node  ( one box) and it is down due to power problem and need to replace with RMA and after getting the new device how to replace it at the DNA as a border and control node ? is there is any automation process i must ...

Hello everyoneRecently our management is deciding weather to invest in Cisco SD Access/DNA center or not.I have looked a bit into Sd Access and I would like to know how it is different and better than traditional switching.If I could get some documen...

Hello All,  Assembling a large SD-A design for one of our customers, and we have devised several topology models to categorize each of their sites against from a design perspective.  We allocate Catalyst 9300 and 9300L's as Edge nodes, depending on t...

Hi everyone,I have one fabric subnet which I use only for ISE Certificate Provisioning. I have WLAN with related subnet. I want people when connected to this WLAN, to browsers pop up ISE certificate provisioning page. I configured WLAN passthrough in...

Hi All,I have my fabric edge switches configured as local mDNS gateway. Chromecasts are connected through AP which are connected to floor edge switches. When I am connected with cable I can scan chromecasts but when I am on same AP with chromecasts I...

customer network can be half of it SD-Access with DNA advantage license on switches and the other half can be work with Traditional configuration with Essential license on switches and the two types of switches can communicate on the same network ?