Storage Networking

After our MDS 9124 was upgraded from 3.1 to 4.2, it now logs in the config whenever a "show running-config" is done. This has somewhat become an issue because we use Cat Tools to backup our configs so when it logs in, it does a "show running-config" ...

Got 3 Qs:1) how do you save the config on N7K, or on NX in general?2) How to do image upgrade?3) Do I need to congif STP? and if so, do I need to config a switch as root? & how I can do that?Thx.

Hi Experts,Do you know where i can find reason as to why one of the MDS switches showing:FS1.DRC# show license usage ENTERPRISE_PKGApplication-----------ROnly Zoning----------- But Nothing shows up for these two other switches. FS1# sh license usage...

I would like to take formal class regarding the Cisco MDS technology. From a deployment/design perspective. Beginner/intermediate level. Does Cisco offer these classes and if so, can someone give me the title of the training class?I am having problem...

On two of my switches I get the following when I run "sh run diff". the other two switches are fine, one of them did show differences but after I ran "copy run start" it clear it.*** Startup-config --- Running-config *************** *** 188,265 **** ...

I am trying to determine the risk of changing my device-alias listings from basic to enhanced.  The documentation leads me to believe that this is a fairly benign process.  Is this a change I need to be concerned with?  The documentation also dictate...

I'm about to setup 18/4 modules and plan on linking those to our DR site that is using 14/2 modules. Any issues connecting those (currently on 3.3.2 code)? And followup question to that assuming it's OK to run like that:Prod site is Gen 2 supervisors...

###################################################Booting bootflash:/m9100-s2ek9-kickstart-mz.4.1.3a.bin ... ##........................................                                             ##Automatic boot of image at addr 0x00000000         ...

Hi,I recently brought a NSS4000 the documentation said upgraded the firmware straight away.This completed successfully to 1.16.Also this version of firmware is very SLOOWW!!!!!!I can get the box to join to the domain ok, but when I click Access-Users...

Hi all,I know that on the MDS-9222i the license SAN_EXTN_OVER_IP is embedded on the integrated supervisor blade and no license is required to use it on the fixed IP port.The question is if I need to do something to enable it and if there is a command...

I was using the online Cisco license registration wizard to get a few licenses from the PAK's I recieved via mail but I made a mistake. When I went through the registration process it asks you for the Serial Number / Host ID. Well I looked at the uni...

DS-C9124-K9MDS 9124 fixed configuration (non-modular) multilayer fabric switch (includes 8 enabled ports; an on-demand ports activation license can enable 8 additional ports, up to 24 ports).MDS 9124 Switch onlyDear sir,      With refer to the above,...

Dear sir,    Any method to perform subject mentioned?thanks.

Dear sir,      Please advise below why i can ping but can't copy the .lic file into bootflash of ds-9124-k9 .  Currently the 9124 have existing running 8 which have default running license. I wish to add on additional .lic for extra ports. Please adv...