Storage Networking

I have configured PM on my Fabric Manager server and verified that the service is running. However, when I look at the PM reports, all the graphs are blank.The logs contain quite a few of the following errors:WARNING 2006/03/23 12:51:23 PM PMStat d...

Hi all,I hope I am posting this question on the right forum. If not, please let me know.I am planning to purchase a DELL PowerVault 132T Tape Library (using LTO3) to backup data from multiple servers and I want to use fiber channel instead of SCSI.I...

Greetings -I am currently in a project to migrate from a single 9509 to dual 9509 fabrics. 90% of the hosts on this intial fabric are HP-UX hosts. They are configured with persistent FCID's...However, when I add the second fabric to the mix, it wil...

Noticed tmf-queueing command under iscsi interface. I understand what is iSCSI TMF, but I'd like to understand what this command does.Thanks!

After invoking the following command on a 9216i.switch#logging server 192.168.231.99 facility local7I'm left wondering what type of logging will get forwarded to the SysLog server.It seems like there are numerous facilities and only the ability to fo...

Hi I've noticed that CTRL+S key combination makes MDS console access unusable until you reboot the switch. Is there a reason behind? Is there a key combination to recover from this condition? Thanks!

Can anyone assist in interpreting the message below. Trying to connect a Windows 2003 Client to an IBM Shark system.Initiator is always showing that a login has failed. 2006 Feb 5 05:25:21 s-do-ra-43-op-4 %IPS-5-ISCSI_SESSION_CREATE_FAILURE: port-c...

is there a way to collect historical port utilization stats in Fabric Manager ver 2.1.2(c)?

My switch has no active ports, when I just run fcanalyzer, I see these frames:ff.fa.01 <-> ff.fa.01ff.fa.04 <-> ff.fa.04Ethereal shows them as "unknown frame"R_CTL = 0x20 (ELS)What are those?

There are a few zones and zonesets that i have not created, but they still show in the sh run, and they show as active.When I try to delete those zones or zonesets i get an error "Zone/zoneset not present" What are these and how you clean them?Thanks

Does this feature operate similarly to FCC rate limiting, by slowing down the rate of R_RDY frames?Or does it do it diffirently?

what command is used to change the admin password of the MDS switches