We have a qlogic HBA (qla2xxx) running on Red Hat that seems to be failing on OS startup. Exactly how its failing I am not sure. The card was connected to a Cisco UCS environment but was removed and is now connected to a cisco 9138 but fails at ...
Hi,I need some advice when it comes to how to setup a port-channel between Nexus 5548UP and a HP StoreVirtual 4330 device. The idea is to use 2 10 GB ports in a port-channel group and this far I've this on the port-channel group; interface port-chann...
I'm trying to pull fibre channel error statistic counters on a Nexus 5596 but it looks like the IF-MGMT mib is not implemented.If there any OIDs accessbale via SNMP to get the following values (Examples from show output in the CLI) via snmp?Input: di...
Hi All,I am pretty new on storage world and now I am working on lab for testing FCoE multihop. I have some questions that need to be clarified and some caonfiguration example that need to be corrected. I have also attached the logical topology for my...
Hello Teamkickstart: version 4.2(7d)system: version 4.2(7d)2011 Apr 14 18:03:43 jiph101f01 %RADIUS-3-RADIUS_ERROR_MESSAGE: All RADIUS servers failed to respond after retries.2011 Apr 14 18:03:45 jiph101f01 %AUTHPRIV-3-SYSTEM_MSG: pam_aaa:Authentic...
HiI have 2 cisco 5548UP in my test setup.I had earlier configured the sw for fcoe with an active zoneset with only the first 4 ports used as fcoe.I now plan to use the last 4 ports 1/32-1/28 as native fc.As a test I connected an 8gb cisco sfp tp port...
Dear All,we have Fabric Manager 5.07 installed on Windows Server 2008. Everything is working fine without this little problem:Every time I start FM I get this Error message:FM standalone was unable to bind to Syslog port as It was already in use, thi...
Hi All,I'm new to Cisco UCS and don't fully understand it's compatibility with non-Cisco gear. My questions are primarily driven around the concept that Cisco UCS smartplays appear to be significantly cheaper than the traditional configurations that ...
We are planning to decomission few of our unsupported storage arrays from environment.Hence we need to remove few zones from mds switch.I would like to ask that if i run no zone command e.g SW1(config)# no zone <zone names>would this be good to remov...
Just purchased a couple of 9216i for the lab. I am looking to upgrade to 4.x software. However, whenever I try to upgrade I get the following error. I can't got to this version. Looking it up, it appears to be an incompatible software image. Ac...
When we create zones, we should use virtual wwn's not physical ones. All wwn's, physical and virtual will go through the same fc port.Believe that the FC traffic would still have to locate and go through physical wwn, then after get to HBA, split t...
Hello all.I need to configure FC for storage in a Nexus 5096UP? Is it possible to make it via GUI (like ASDM for ASA)?I have read some docs and they all refer to Fabric Manager Server. Is there a more simple way to do it?Regards,Joao. ...
Well there's two problems I'm currently having.1. Installing DCNM onto a windows 8 machine, I ran into a problem the 1st time I tried to install in that PostgreSQL doesn't like to be installed under program files in windows 8. It's a permission issue...
