9300L in stacking H/W version is a mismatch.

[alex2014a]

I have a stack switches with v-mismatch on H/W version (V01 and V05). All switches are in install mode
How compatible are then with each other?

switch#sh platform
Role Mac     Address Priority Version  State
----------------------------------------------------------
1 Active    1111.1111.1110 15 V05 Ready
2 Standby 1111.1111.111a 13 V01 Ready
3 Member 1111.1111.111b 11 V01 Ready
4 Member 1111.1111.111c 9   V01 Ready

Switch Ports Model              SW Version        SW Image              Mode
------ ----- -----              ----------        ----------            ----
*    1 53    C9300L-48P-4X      17.06.03          CAT9K_IOSXE           INSTALL
     2 53    C9300L-48P-4X      17.06.03          CAT9K_IOSXE           INSTALL
     3 53    C9300L-48P-4X      17.06.03          CAT9K_IOSXE           INSTALL
     4 53    C9300L-48P-4X      17.06.03          CAT9K_IOSXE           INSTALL

----------------------------------------------------------

[Mark Elsen]

            - They are compatible, 

 M.

[Kasun Bandara]

you can stack them together.

[alex2014a]

thanks. Is there a Cisco release note or other document that confirms this?

[Kasun Bandara]

mainly compatibility depends on device model and OS version.

[alex2014a]

hanks. Hardware model and software is identical as above. Only v-mismatch on H/W version (V01 and V05) in stacking.
Is there a Cisco release note or other document that confirms that v1 and v5 are compatible in stacking mode?