Hi have a problem upgrading a WS-C3650-24TS Stack with two switches.Upgrade is from 16.3.3 to 16.9.5 But is fails with the following usage.It also complains about a missing file cat3k_caa-rpcore.16.03.03.SPA.pkg,but when i check the flash content, th...
My router with rare exceptions was solidly running a VPN to my provider for select devices on my network using PBR with the config below.1. now in those rare exceptions the link would go down those select devices would connect to the internet via def...
Hi everyone, The following image shows part of our network. We got a problem as follows: Sometimes, we can ping Client 1, but we can't ping Client 2 from the 2960 Switch. But, at the same time, we can ping both clients, 1 and 2, from the 3560 Switch....
I am new here, first time creating a discussion. So here is a scenario:I have a router configured for encapsulationint g0/0/0.10encapsulation 10ip address 192.168.10.1 255.255.255.0exitint g0/0/0.20encapsulation 20ip addression 192.168.20.1 255.255.2...
Hi there, can someone explain why i cant copy the config onto the 9K? Thanks Below is from the current 5Kinterface Ethernet2/1 switchport mode trunk speed 10000 channel-group 201And when i copy it into the 9KSwitch1(config)# interface Ethernet2...
Hello, I am tasked with sending logs from specific interfaces to nagios syslog server. Here is my configlogging 10.1.2.2 logging trap 6 Logging source-interface GigabitEtherne...
Hi,I am using Microsoft Network Policy Server 2019 As Radius server for my switches and so control logins using active directory groups.From last one month I am scratching my head. I am very new to Radius so please help me.I am getting this error. Ap...
Hi.I am trying to build vWAAS using KVM.We will be installing KVM on a server that is not a UCS server.There is one thing I want to ask before installing.Should I use only CISCO network cards?Can I deploy vWAAS with any network card?
Hi !I like to use Microsoft Network Policy Server 2008 As Radius server for my routers and so control logins using active directory groupsI think i did it all correctly but i get authentication failureand I should add that i have tested it both with ...
Hello, I have a Cisco Nexus n3k-c3048tp-1ge to which I have connected several devices.I also have a firewall so most of the ports are blocked between the different networks.For a specific application we have port 555 open, where the default is 1111. ...
We have two SG550XG324T stacked together (Firmware ver 2.5.0.90) and setup LAG (No enable LACP) say 1/5 and 2/5 connected to Xen server (Bond mode Active-Active No LACP)IssueBoth port always up and down and one of port (1/5) automatic from active me...
I finally setup my first router and switch in my house and cant get it to work. Cant get to the Internet. I know im overlooking something. Can you guys please look over my configs? (fa0/0 on router temporary shutdown on purpose) --------- UPDA...
Hello everyone, I'm quite new with PT,I'm a student in some Audiovisual School, and i'm in charge of the network part.I'm trying to make my Audiovisual school's network Topology on PT, but i got a few problems. We are using Layer 3 Switches as Cisco ...
Hi to All Tech Experts! I am looking to deploy new Network in a Power House based on Ring topology Using 9200 24 port. I spotted 09 Nodes for using access layer switches. Distance between each node varies between 50m to 70m. I am not network e...
