Buy or Renew
Buy or Renew
NOTICE: You can now engage in the community. Learn about the great new Cisco Umbrella content.

Switching

Discuss Catalyst brand switches with peers and experts.
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation

Get 20% off switches when you combine Cisco solutions

 
Labels

Forum Posts

Start a conversation

Resolved! Vlan removed after the switch reload.

Dear TeamI have an access switch (C2960S-48FPS-L) which is running on version (universalk9-mz.122-55.SE5).This switch was running on VTP client mode and connected to distribution switch running on VTP client mode and vtp version 3, due to power failu...

How can I configure ACLs on VLANS?

Hi,I have a small busines sf300-24 switch. The point is that I have 3 VLANs, VLAN 10, VLAN 20, VLAN 30. With an interface ip 192.168.10.100/24, 192.168.20.100/24, 192.168.30.100/24 respectively. The switch is in ROUTE mode and have activated the ip r...

Resolved! create new vrf in N5548

Im trying to create new vrf in Nexus5548 but i got the below message switch(config)# vrf context salem% VRF creation from cli not allowed on this platformswitch(config)# Here is the Version and inverntory for the switchSoftware  BIOS:      version 3....

Cisco SG500X 48PS versus Cisco 3650 48P?

We have an office that wants to upgrade their switches to the SG500X 48PS with POE across all ports.  Our standard has been the cisco 3650 48PS with POE across all ports.  From what I am reading both support intervlan routing and support similar feat...

Netflow on 6509 in Native Mode from Vlan Interface

I'm trying to get a 6509-E, running Cisco IOS Software, s72033_rp Software (s72033_rp-IPSERVICES_WAN-M), Version 12.2(33)SXI9, RELEASE SOFTWARE (fc2), to send netflow traffic from a vlan interface to a Solarwinds server.The server is not seeing all t...

rdotson by • Level 1
  • 293 Views
  • 1 replies
  • 0 Helpful votes

Resolved! Too many broadcast

Hi,We have a monitoring system that gathers statistics from our switches.  From those statistics, we have established some threshold for excessive broadcasts.  If they are exceeded, an alert is sent to the network team.  The threshold is set for 80 p...

tonyp8581 by • Level 1
  • 3645 Views
  • 5 replies
  • 0 Helpful votes

CSR 1000v bandwidth very slow

hi,I am using CSR 1000v in my environment and noticed those machines which linked to int gig 2 communicate very slow with machines linked to gig 1,like if I copy a file, speed is about 300kbconfiguration is minimal, only ip addresses are configured w...

View All
Review Cisco Networking for a $25 gift card