Switching

HI, I need a configuration of the attached pictureI created three vlan 10,20 and 30 Vlan 10 and 20 should communicate the web server (vlan 30)but vlan 10 and 20 cant to connect

Please any one can help me to resole my issue. As you known number of outdiscard in some interfaces are very big, how can I reduce this number.All of port is connected to camera and now all of thing are OK.Many thanks all of you in advance.EDS-A00-Di...

Hi dear cisco lovers ,I have a huge problem ,I have 2 6506 switches which I have configured VSS between them, suddenly I have been informed that one of switches didnt respond ,I mean VSS is not up .I realized that one of them has completely lost its ...

Hi All,Can anyone help me by providing the IPFIX (NetFlow Version 10) Flow-Record Format..Thanks in advance..Regards,Jijo John  

Hi, We have Cisco 3560X switch and has uplink module of 10G-SR unable to change speed setting on the switch  and IOS version it has 12.2.53 SE2 universal k9 image. Any inputs will be helpful here. Regards,Santhosh

Is it possible to improve the switch to boot under one minute. I need this because my locals computers boot faster than the switch and they are unable to reach the server so they crash. Can we disable all the diagnostic test at the startup ? I'm usin...

I have new project for our company that needs to get a solution. Our company have current network using ISP router and only HUB.Here are some basic info.1. There are two Public IP Addresses configured on The ISP Router - One is for Internet and one i...

Hi We have a strange problem, there is a stack formed of three 2960x switches (same model and IOS),  and third member reports strange messages in log regarding inline power:14181681: 14008908: Jun 30 08:39:07.998 UTC: %ILPOWER-3-ILPOWER_INTERNAL_IF_E...

In remote location, the 3750x core switch is configured in stack. Six department's stacked Access switch is connecting to the 3750x switch with fiber as uplink, which is configured again in trunk  port-channel.As I mentioned in Summary,We have more t...

Hi, Just wondering if there is an option  to stack 2960 and 3560 switches. Thanks,Sridhar

Any good reading material on Cisco NAC i can read up? Thanks,Jack 

Hello,Sorry i'm new to the forum. I need some help figuring out how to enable mab ! I entered the following commands on the switch********************aaa new-modelaaa authentication dot1xdot1x system-auth-controlradius-server host IPradius-server key...

Dear all,  in my cisco network, access machines are connected at each location, to take these machines on network we bind the MAC,VLAN, IP address, and interface on cisco switchport using logs.But we have issue at one machine(static ip configured), w...