Switching

hiI need help about Cisco switch 2960 issue how i give IP address gateway in switch if there more than two vlan  and how configure  telnet command plz help me   

Hi,      Been scratching my head for a while now, i don't know why a switch even has the " Ip helper address" command, Dosent it need routing to acomplish this kind of a task? I have a switch with 2 SVI's, fair enough, one for Vlan 10 and the other f...

After configuring SPAN on 2960, IDS can't connect to anything, IDS & PC client same switch on 2960Please correct the below configuration. interface GigabitEthernet0/1 description " To L3 3750" switchport mode trunk!        interface GigabitEthernet0...

Good day! As it stays in Cisco docs STP logical ports number is calculated by formula:Sum [(Each trunk on the switch) * (Active VLANs on each trunk)] + (Number ofnontrunking interfaces on the switch)And this number can be checked by issuing commandsh...

At Router Privileged mode , those following commands: config tint f0/0no ip addressno shutdownint f0/0.1encapsulation dot1q 1ip address 10.0.0.1 255.0.0.0int f0/0.2encapsulation dot1q 2ip address 172.16.0.1 255.255.0.0end i find it in a book...may i ...

Looking for some feedback on the following scenario: We have a two switch stack where each switch is connected to each of 2 firewalls so that if one firewall or one switch fails, we don't lose our connectivity to the other end of the link (a matching...

I am new at this so Im sorry in advance. I have created Vlan 20 on Sw 1 and Vlan 10 on switch 4. Both with ip address in the same subnet. I cannot however seem to ping. What should I be taking into consideration? Both switches are Catalyst 3750. I'm ...

Dear all, I have 2811I want to know1. how to verify current CME and CCP version2. where to download latest version3. how to upgrade them thanks

Hi All,I have searched this forum and cannot find anything similar to the scenario I am currently presented with.Is it possible to create a VPC between a pair of Catalyst 2960X (24 & 48 Port) Flexstacked together back to a pair of Nexus 5596UP switch...

Hi,I currently administer a remote site connected via a 100 Mbit leased line and a 50Mbit microwave link for backup configured for failover via Spanning tree.What would be the best way to combine both links together to increase throughput? I am assum...

I am trying to setup 802.1x on a 2960 running 12.2.53 SE2.Here is the configuration of the interface:interface GigabitEthernet1/0/9switchport access vlan 205switchport mode accessswitchport nonegotiateauthentication event fail action authorize vlan 2...

Hello,we have a connection from a service provider between location A and B where in location A i have an ethernet port and i configure a switch interface as trunk with 802.1q encapsulation and i try to pass vlans 421-423. in location B the ethernet ...