Switching

Discuss Catalyst brand switches with peers and experts.
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

Labels

Forum Posts

Hello, Cisco Community!I’m really happy to share that I’ll be hosting the Cisco Community Lab Series, a brand-new hands-on learning journey designed to help you build practical networking skills step by step.Every Thursday at 8 PM EST, I’ll post a ne...

in my office, people bring their laptops and connect to the network.Since we have dhcp allocation of ip addresses,an ip is provided to them and once they disconnect, the address is still in an allocated state in the dhcp server. Can anyone tell me ho...

Hello,I having issue where 6 WLAN AP's not coming back uo after reboot and IOS upgrade of 3560 POE swtiches - . Prior to changes here most if not all ALL the 23 Aps were mainly on one switch, Now after these changes they are now spread over three swi...

Hi folksI remember not that very long ago I saw a document that was depicting the QoS order of operation for both ingress and egress data flows on the Cisco 3560/3750 series.However, I'm at a loss right now as I cannot find it, apparently I didnt boo...

I'm pretty sure the answer is "NO" but is anyone doing any kind of Nexus emulation (legally) for training/learning purposes?Dynamips - NOI.O.U. - NO (I think)Others?If this isn't the right forum please redirect me. Thanks.

chenson by Level 1
  • 2900 Views
  • 6 replies
  • 0 Helpful votes

Hi Guys.. I need your help regarding cisco switch I want to know that my cisco switch is original one or chinese copy.Kindly share the method for finding it. Regards

Does anyone here operate their routers & switches without a username specified? We don't use the username in our login or enable authentication (use vty and enable passwords), just wondering if there is some requirement for a username that I don't kn...

our isp had assigned /29 range ip address to us. These ip address are mapped to private ip using nat. We ran out of this public ip and requested our isp to assign new range of public ip, they assigned /29 range we have an web server that host about 1...

rsvinay89 by Level 1
  • 492 Views
  • 1 replies
  • 0 Helpful votes

Hi,Has anyone used a 100Mbps SFP with this EHWIC module?I want to use a GLC-FE-100EX SFP with this module but there aren't any 100Mbps modules listed in the table of supported SFPs in the following link:http://www.cisco.com/en/US/docs/routers/access/...

johncapr0 by Level 1
  • 553 Views
  • 2 replies
  • 0 Helpful votes

In the event that I have a pair of HSRP routers that also act as DHCP servers, what is the best way to avoid an IP address conflict? I don't want the Active Router to give out an IP, fail and then have the Standby (now the Active) give out the same I...

Hi All, I would like to configure my core switches as the ntp master for the environment but also I would like to have the core switch sync with a public NTP server. Can you advise if this is possible? I have seen both commands available on the switc...

rramlal by Level 1
  • 964 Views
  • 1 replies
  • 0 Helpful votes

Hello, I can't get a grip on the IOS versioning numbering.Taking 12.2(44)SE3 as an example, (44) sould be maintainance number and the 3 of SE3 sould be the rebuild number. What is the difference beween these?An higher maintainance number of a softwar...

dennisv99 by Level 1
  • 1274 Views
  • 7 replies
  • 0 Helpful votes
Unanswered Topics