Switching

Hello, I'm trying to configure a rate-limit in a 3750X but I'm not seeing any result...  These are my configurations:RF#show run Building configuration...Current configuration : 23410 bytes!! Last configuration change at 08:53:35 UTC Sun Mar 14 1993!...

Hi,i have a 3750 switch that when i want to add an entry to access list i receive the error:More than 5000 entries can not be added to the ACLwhen i remove and reapply the ACL the new entry is added correctly with out any issue. Please advise.

Hi,we are evaluating VSS/VPC technology for use in Core and Distribution Layer Routers (Cat6K, Cat4K, N7K).The benefits are clear so far (no stp, no hsrp, full bandwith, easy routing design etc.), but we are still discussing the resilience of the two...

Hi Everybody: Im conecting a phisical trunk, between  switch Dell PowerConnect 5324 and Cisco 2811 Router, please see the attachment topology, I can't not ping between the PC A and PC B, I will show the configs:The config in the router CISCO:!interfa...

Hello all,Please see attached file first.We have two existing Cisco 3650G with root/secondary bridge for resilience, now we want to add two Cisco 2960X with stack and for two server resilience with LACP, is it possible to do that ?Thanks

I have 2 3750 switches stacked, I have 5 3560G 48 port POE switches that connect back to the 3750. If I reboot any of the 3560 switches the vlans on the 3750 go up and down.I have contacted TAC and they switched out the 3750 but the issue still happe...

Hi, As per my knowledge, when we use udld on global mode it is applicable for fiber port only , not on Ethernet Port For applying the same on ethernet Port, we need to neable udld agressive mode on the ethernet interface. Pls confirm whether for ethe...

Hi,I'm deploying OSPFv3 AF and have trouble injecting a default route (conditionally) with a NSSA. I'm trying to do this on a CE as we have firewalls connected here. The below scenario works with OSPFv2 by the way. The basic configuration is this: !P...

I'm troubleshooting a problem with an IP phone (brand Aastra) and Cisco 2960X switch with PoE. The problem is that some of the phones does not power on correct.We've talked to the supplier of the IP phone and they have asked us to use this command on...

Hello Friends, I have the task of des promote a Switch 3750G a stack that is composed of 4 Switches 3 of them are 3750X and 1 is 3750G, which occupy remove the stack is the 3750G it is a member of the stack NO is the master, I have no clear steps to ...

Hola Amigos, tengo la tarea de des-promover un Switch 3750G de un stack de que es integrado por 4 Switches 3 de ellos son 3750X y 1 es 3750G, el que ocupo quitar del stack es el 3750G este es un member del stack NO es el master, no tengo claro los pa...

This is a follow-up of a question I asked here: https://supportforums.cisco.com/discussion/12180986/rv220w-only-routing-icmp-traffic I have a recently-purchased rv220w wireless router.  My setup is as follows:  Internet -> asa 5505 -> 10.0.1.0 subnet...

hi all, right now i am having 6509 2 core switches running with hsrp . now i added one more new switch 4507 , is it ok to configure this device also in the same hsrp group? because we have connected all our servers to this new switch if anything goes...