Switching

Hi All, I acquired a 3560X-24P-L Switch which I wanted to use at our datacenter.  However, I need a switch that supports OSPF.  It came with a Universal IOS but there was no "Router" command under conf t.  I downloaded and applied the latest "IP Base...

i have a cisco 3130 and 1 nortel passport 8010.on cisco switch i have vlan 1 as native and used as managment Vlan.on nortel switch i have Vlan 22 as native and used as Managment Vlan.This is production envirnment and cannot change these settingsThese...

This is for a short temporary time until I get cisco 3560s in place. I have a 2921 configured  and it is connecting to an HP non managed non VLAN switch and I cant get any traffic to pass from my computer to the router (pings or anything). Here is br...

Platform： CISCO 6513-ELinecard：WS-X6724-SFPIOS ver： Version 12.2(18)SXF17b, RELEASE SOFTWARE (fc1)Objective：Police the traffic if it exceed and guarantee the bandwidth when congestion occur on egress。Q: This LAN port doesn't support MQC. We use Port ...

Hi,   I am using Nortel 5650TD and Cisco 2960S switches. Vlan 50 is a managmnet Vlan for nortel and the same Vlan 50 as configured as a trunk native Vlan on Cisco side. Vlaan 50 has IP address which i need to use for managmnet of switch.Vlan 10 has c...

hello,i want to know, is c3650G or c3650X switches are already containing rack mounting pack or am i need to buy it seperatly?

I cannot get a route map configured on my new Cisco 3560X. When I go into the vlan to apply the routemap the configurationwill not accept the ip policcy command.

As some of you know, I am working on a University project designing a network. I would like to know if it is justifiable to use fibre between the core and distribution of a network with around 300 users?Or could someone please tell me when would be a...

Hi there, Does anyone know if you can get fibre optic modules for Cisco 2821 series router. I can not find anything apart a SFP module which contains only one SFP port.ThanksTony

I have a Cisco 6513 switches connected to HP VC Flex 10 Module.  The (2) 10Gb ports on a Cisco Switch connected to VC Flex-10 in LACP mode.I need to move those (2) 10Gb ports on Cisco Switch 10Gb Module to a different 10Gb module on a same Switch wit...