Switching

Discuss Catalyst brand switches with peers and experts.
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

Labels

Forum Posts

Resolved! 2950 to 2950

I have a 2950 that connects fine to an old d-link.  Now,  however, we're puttingin a wlan and we're putting that on it's own vlan (the LAN only has 1 vlan). So, the d-link has to go as it doesn't recognize vlans (a really old switch).I replaced the d...

paulc by Level 1
  • 5410 Views
  • 4 replies
  • 0 Helpful votes

The company that I work for has a vlan setup for each floor and each floor is connected via a switch which is then trunked to the management switch. From my understanding of a vlan, the purpose is to logically connect machines that are not physically...

Hi all, with COS, does this actually provide you with a mechanism to prioritize the traffic as it stands for class of service, not quiality of service, and this all happens at layer 2 ?

Hello,I am trying to classifiy incoming packets from IP phones using ACL. Below shown my detail config. However, when I use Wireshark and check packets arriving from IP phone, it shows DSCP=0.  It seems teh ACL doesn't applied on the access port.FYI,...

Hi,I'm completing my first vss software upgrade with efsu.  I followed the procedures but I'm getting an error message when trying to load the issu loadversion command.  (must be named first in BOOT [ bootdisk: ]).  The current running image is locat...

Hi,  I have a peculiar issue since Monday Jul.5,2010. There was network loop which slowly freezing my network & intermittent disconnections to the server sessions from the workstations. When i logged in the core & access switch, i saw the log  asJul ...

Hello all,We are having a cosmetic problem with a etherchannel connecting 2 Cisco 6500, via 2 gigabit interfaces in each side. The link is okay and is it working fine, is more a cosmetic problem. The devices are directly connected and when we do a "s...

Hey I'm trying to convert the FreeBSD servers at work to dual-gig lagg links from regular gigabit links. Our production servers are on a 3560. I have a small test environment on a 3550. I have achieved fail-over, but am having troubles achieving the ...

Greeting.We knew that, if we advertise default-route to all ospf domain, we should confiigure 'ospf default-information originate' in ospf process.However, but some ios, or version, We can do as following to advertise ospf default-route. ip route 0.0...

syjeon by Level 1
  • 1439 Views
  • 6 replies
  • 0 Helpful votes

Hi,I have a cisco 3750E running c3750e-universalk9-mz.122-53.SE2.bin. The ip policy route-map command is not available under the SVI. Any ideas why?Does this switch not support PBR?I configured the sdm prefer routing and rebooted, still the command i...

I want to keep inter-VLAN routing on the switch (about 10 vlans with L3 routing) and for some VLANs I need different gateway. I tried to run PBR on incoming vlan. interface Vlan10 ip address 10.10.10.1 255.255.255.128 ip policy route-map test inte...