Switching

Hello, Im having an issue with my VTY sessions are not closing.  They are stuck in Idle mode.I also tried clearing my sessions manually and still will not clear out.I know a reload will workHere is what I have.IOS - c3750-ipbasek9-mz.122-44-SEModel -...

Hi guys,have you come across this error unknown protocol drops which is seen under show int for either tunnel int ,gigabit ,serial or fastethernet.Please let me know how do we overcome this error or is there any fix on this error.ThanksSanjeevcom

Hi, folks:I'm looking at a data center of a company that has a huge enterprise network. The server farm uses a switched access layer and a collapsed core comprised of two 6509 switches. They have about 200 IOS SLB instances, with probes, configured i...

I have an old catalyst 2900XL switch that I want to use as an unmanaged swtich.  For some reason it does not work.  The setup I am using to test this works with a netgear so I know it is not the cables or the devices.Can someone please let me know wh...

Dear AllI have cisco 4006 as centrel switch and it is connected with diffrent cisco models like cisco 2950 from other locationsi have 4 subnets connected with cisco 4006. it is possible to do routing on this cisco 4006 switch if possible then tell me...

I am implementing NIC bonding/teaming with Catalyst 2960.Linux_A has both NICs connected to the Catalyst 2960 witha bonding interface. I setup the catalyst with EtherChannel as follows:interface GigabitEthernet0/2 description Generic dual-processor ...

Hi,I've seen comments where people say you don't necesserially need to run STP on switches. I'm confused as to why people say that, a few questions on this1. If they don't run STP then what do they run2. How do people take care of redundant paths and...

Hi Guys,I am trying to understand Dynamic VLAN assignment using VMPS. The VMPS Client switch is a 2924XL with proper IOS. It is configured for VMPS as follows-vmps server 192.168.3.2     ! Location of VMPS Server...confirmed reachability from Switch ...

Hi AllI require some assistance with my 877 router. I recently performed a  factory reset by pressing the rest button within 5 seconds of boot.  Since then I can get no connection to the router at all.  None of the interfaces appear to be active so c...

Hello,Can we stack  WS-C3750G-24PS-S with WS-C3750G-48PS-S with the same IOS version?Also how many switches we can stack in one master switch?

I have a problem in NTP server below our current seniorWe have configure Router 2800 as a NTP server to provide time for CUCMWhen we configure before it was working fine but suddenly we found there is some time deference on all telephones connected ...

Hi Ciscoers,I have 2 cores 6513 equipped with 2 modules which each having x16 SF ports.2 cores connects to about 9 Dist Switches as active and 9 DistSwitches as passive (typical cisco design for HSRP).Which:-CoreA should have 2 legs to Dist_A and Dis...