Switching

Hi ,I have a requirement to configure mtu size in cisco 6513 series core switch on SVI interface. I would like to know the impact to the other SVI interfaces and in general whether is it best practice to configure mtu on SVI interface or leave it to...

Hi,AllCan i use 6500 switch as SP edge router to connect to 2x500 internet links and for full internet routing support?

Hi all,I wonder if you can help..I have just set up my cisco 837 and works fine...however i am trying to use the SDM with it and it wont work...I open SDM Launcher, enter the IP address and click launch, Im then presented with an IE window with the s...

Can I configure a dot1q trunk with "switchport trunk allowed vlan none" for the sole purpose of checking connectivity without passing any traffic. Do the switches just send BPDU's for the native vlan and nothing else.

I have 2 questions1. I would like to paste a commands in without seeing them echo back is there a way to temp turn echo off.2. With ssh on is there a way to connect to a switch through cluster or something similar reason why there are times people fo...

Hello: We have been tasked with migrating a Lucent 6000 PBX extender from its conventional WAN connection over a channelized voice-grade T1 to a Cisco 2821 ISR router. Basically, what we are being tasked to do is migrate the T1 connection from the PB...

If you do a "sh queueing int gx/x" on a 6500 IOS box, you get a bunch of info on the queue of that particular port. At the bottom of the display are counters for dropped packets in the various queues for tx and rx as shown here: Packets dropped on T...

We're having an issue where we are seeing high output queue lengths on many of our windows server hosts connected to a 3560 switch. The queue will often times be above 5 or 10 deep with .01% utilization on the NIC.The servers have been swapped, driv...

Hello Experts,Can I use the stacking cables from C3750 with CAB-STACK-xxx part numbers instead of STACK-CAB-xxx listed for C2975? What is the difference, except the price?regardsalex

Greetings, I have a 350 card that I had directly linking to a cable, then antenna, for Internet. Recently I got a new computer with Windows Vista and placed the board and card into it. Vista asked for drivers for the new device. Where can I get the d...

have port security configured with the following config on my 6513 running 122-33.SXH3a.switchport switchport access vlan 101 switchport mode access switchport voice vlan 102 switchport port-security switchport port-security aging time 2 switchport ...

hi we got here 2 x 6509/Sup 720 running 12.2(18)SXD2. Some 2950 Access switches are connected via trunk (12.2(18)SXD2). We have a Novell DHCP/PXE Server running Netware 6.5. On our core is a HSRP process running *.253 (core1) *.254 (core2) + virtual ...