I'm new to network installation and configuring so might not have the question stated very precisely. I have a Catalyst 9130AXI-B ap and would like to connect to a cisco IE4000 switch to enable our lab network(without internet connection) WLAN capabi...
Forum Posts
Can a WS-C3560CX-12PD-S switch be configured to be a WS-C3560CX-PC-S switch?? I don't need the stack functions and I already have some of the PC versions. I just want to simplify the system so I can access each switch GUI and setup to be the same. ...
Can anyone confirm if the Catalyst WS-C2960XR is affected by the BUG-ID CSCuo89272. We are running version 15.2(7)E5.The platform is not listed in the affected products.
Recently, I was assigned to do IPV6 RIP 1.pka by my lecturer. However, I can't complete my task because pkt tracer won't read my "ipv6 unicast-routing" command and it won't read my other command as well. Please help me.
Resolved! "Warning-Packet Discard(s)" Message
Hi All Got a weird one for you. thought someone on here might have an idea of what is going on or can point me in a direction. haven't seen this before. interface is active, connection is up. nothing is listed in the log for the switch on gig1/...
Resolved! C9300 UPOE +
Hi,I have a question regarding UPOE+ and POE, POE+, if I have a C9300 with UPOE+ can are POE or POE+ devices supported? Thanks
My network has two switches both are 9200's all user on SW2 can access everything with no issues, but any one who is on SW1 gets timed out wile tiring to go to google.com you can go anywhere else including other country's version of google (.cm, .cl ...
Hi,What are the pros and cons for running multicast routing and unicast routing on the same core swites and access layerThanks
Morning, On Friday I can configured one of my customers 6506s to export NetFlow to Scrutinizer however coming in this morning it has barely reported a peak over 7Kbps of traffic whereas on our bandwidth monitoring system the interface ha shown over 1...
I upgraded a couple of C3560CX's to 15.2(7)E6 recently. Its a routed access switch with three VLANs/SVIs - Data, Voice & Guest. The Guest SVI has an inbound ACL attached that permits DNS, DHCP and a couple of other things to the LAN. There is then...
Hello everybody, we are running a pair of c9500-32C in stack wise virtutal mode and are experiencing some problems regarding multicast forwarding. Right now, we have:IP Multicast Statistics713 routes using 1157112 bytes of memory323 groups, 1.20 aver...
Hi, I'm currently trying to build a small network with two 3650-24ps Multilayer switches at the distribution level in packet tracer. I want to enable HSRP and configure a virtual default gateway interface at 172.16.100.1 for both Multilayer switches ...
I can't find the doc to explain the switchport mode for SPAN. 1. if source port is switchport access vlan x, should the destination port follow exactly?2. if source is mode trunk, destination port settings should follow?
Resolved! C9407 port channel with FPR 1150
Dear all I have one problem with Port Channel, the network topology is as follow : -- two Core switch C9407R connected with VSS-- two FPR 1150 as (Active-Standby) with port no. 8 -- Creating port-channel ID:13 between the core switch and FW 01 ...
Hello guys,I have a stack of 2 x Cisco SX550X-16FT 16-Port 10G Stackable Managed Switch.Currently the second one has been shutdown due to replacement of their stack fiber in between from MM to SM.Now, I have the first one forwarding traffic correctly...
