Switching

Am trying to remotely upgrade my IOS from IPBase. Never done this before so I need to try this out on a spare router before upgrading on the live device. Can anyone pls help me with step-by-step procedure on how to accomplish this?Regards

Hi all, To be short, I had a small disagreement with a colleague about some issues we were having with our IP phones, Basically all the IP phones stopped working at certain intervals. At this tim we saw FCS errors on the main port into the phone syst...

Hi All,I have this small doubt, I have trunk port configured as belowinterface GigabitEthernet1/1 description entra switchport trunk encapsulation dot1q switchport trunk native vlan 999 switchport trunk allowed vlan 1,199,542,999 switchport mode trun...

Can any one help me the difference between LAn Base IOs image and Lan Lite Image for Switches.

Dear Netpro,I am curious to the usage of ip broadcast-address. I have a loopback address defined, e.ginterface Loopback0 ip address 1.2.24.70 255.255.255.255 ip broadcast-address 1.2.24.70!However, when the NMS do a snmpwalk to this loopback, the rou...

hi all, if I have 2 routers, what happens if you have 2 eigrp processes running between them advertising the same routes in each AS. Which one would work the lower AS number process ?

Hi All,Anybody knows the default sleep timer value? For e.g RIP has Hello Time - 30Sec.Invalid - 180 Sec.Holddown- 180 Sec.Flush - 240 Sec.What abt the Sleep Time?Thanks in advance.

Can anyone please provide me with the information of how to change the BAUD rate.. As i just upgraded my IOS, 2950 switch, and in order to do that i had to increase my BAUD rate from the default 9600 to 115200 bps.. Now whenever i try to access my sw...

Hi all, Could help in finding out the module BF-S720-64MB-RP,MEM-C6K-CPTFL512M,CF-ADAPTER-SPof 6513 Switch ,which command i have to use like sh version etc,,

Hi, I am currently searching for a method to use an Ethernet interfaces as a backup route to a primary Cellular connection. The catch is that the FastEthernet port needs to enabled/disabled based on Cellular signal strength. Alternatively the Etherne...

Hi allI have a issue i have 400 Linksys SRW208P but there Firmware Version is 1.0.1 and i want to upgrade firmware when i did upgrade it bcome disconnect so .Is there any way through which i did remotely access the Linksys SRW208P and did remotely up...

I will come directly to the point as the problem that i am facing itself is quite big..Starting from the beginning, i used the "erase startup-config” command on my switch and then later on reloaded my switch and when it prompted me i saved the chan...