Switching

friends, Eigrp will have "Six" entries in routing table for same destination,Default is "four", set to "one" to disable load balancing, if that is the case, why load balacing needs to be disabled, its good in case of link failure when the primary rou...

Hi all, when I make a connection to say a web server, my pc uses a random source port to destintation port 80 on the server, what would the source pot be from the webserver to my pc, would it be 80 ?

Friends, Pls let me know the difference between the wildcard mask and subnet mask.regardsSara

gusy i m bit new and i cant get my head around to a v simple thing.....suppose we have three switches A , B , C. a server is connected to a C switch and the port is gig1/5 (layer 2 switch 4948). Switch B is another layer 2 switch and connected with s...

After a configuring disaster, I reset the router to the default configuration. Per instructions in "Cisco Router and Security Device Manager Quick Start Guide - pages 16-18, Using the Console Terminal, I configured the running configuration (default ...

Hello All,Im having a heck of a time trying to get the switch working for the lab i purchased off eBay. Its likely that the switch may be faulty, its seen better days.I have been trying to get the latest IOS on the switch, as theres alot of features ...

I have 12 stacks of 4 and 5 switches.2 of them have failed recently with 3 year old stack wise cables.Friday last had a cable failure and today in another stack I found this error message when direct connected. I cant reach it from the management ip...

Hi Guys,Can anyone explain me the useage of null0 in the routing table.Why it is used and in which situation we should use it.Any help is appreciated.ThanksMahmood

Does anyone know of a tool that will follow MAC addresses before and after a switch migration? I am looking to validate on a MAC basis the Vlan, speed, duplex, auto, description and connection status following a move. I am really wanting a tool tha...

Hello folksAnybody can explain me if WiSM (Wireless module) works with CatOs 6513 and 6509 or not? I have found in cisco WiSM Faq that WiSM can not work with 6509 that runs in hybrid mode and I assume hybrid mode runs CATOS in switch and IOS in route...

Hello all,All of my Cisco experience has been with switches and routers. I was recently given a PIX 501 to configure (obtained from old client).First wall to get by is logging in. No one seems to know login info. Ideas?Next is configuration. PIX ...

I have been trying to determine what I need to set up a lab at home for the CCNA. I am trying to get suggestions on equipment, does anyone have a good suggestion as to what I should purchase for a good basic lab?

hi all,i have alert that showssh int vlan6Vlan6 is up, line protocol is down Hardware is EtherSVI, address is 0017.95ab.1130 (bia 0017.95ab.1130) Description: ProSoft_MAS Internet address is 172.29.12.1/24 MTU 1500 bytes, BW 100000 Kbit, DLY 100 ...