Switching

please how do i configure my cisco router to be sending SNMP traps to my monitoring software OMNIVISTA

Hi all!!We have a new Cat6500 Chassis.All Modules: Sup720, Line Cards, and Service Modules aren't new (they don't come with the Chassis).Some days ago, the switch was turned-on, but not in Production yet.The following messages appeared:Jul 27 07:03:2...

Can I do the routing on the cisco switch 3650?May I know how to do the intervlan on cisco switch 3650 so that I can let the user on vlan2 (cisco switch 2950) to use the printer on vlan3 (cisco switch 2950)? Please provide me the example like coding a...

Hi AllPlease how do I configure storm-control broadcast level 0.10on a Switch running CatOS?Thanks

We have two servers connected to the same 4500 Multilayer switch, the two servers are working in active/stanby mode using virtual IP address between the two servers. On the 4500 switch, the MAC address of the servers virtual IP is the MAC address of ...

I have several servers that we are about to deploy Oracle RAC to. Each of these servers have 6 NICs. We would like to take 4 of the NICs and dedicate them to the RAC interconnect in bounded pairs. I would like to bound 2 NICs (for ~200MB of throughpu...

I have an issue with a 3560 switch. I am trying to update the IOS, but it won't let me copy anything.I'd try to reboot it, but I already deleted the original IOS file to make room for the new on.I cannot copy to/from anywhere. If I try a copy run s...

I need a support document that explain the impact in performance when I cascade several switches does any ou you have any link?regards

I'm trying to implement HSRP for redundancy between two Gateway Routers. The problem is currently there is no dynamic routing setup for testing purposes. So there are only static routes in the gateway. That causes a problem for me if I give a new vir...

Hi there,I will very much appreciate suggestinos on the following problem.We are stting up a new network with HA and redundancy.We are using 2 2811 routers connected to 2 catalyst (one 4006 and another 4507).2811's are acting as DHCP servers, and for...

Dear sir, iam having 2 broadband serviceses from different isps so iam planing to do the loadbalance and automatic failover so plz suggest me if router require or any switch(managble switch require). plz give me the best possible. Thanks&Regards srin...

Hi All,We have a catalyst switch 2960, this switch will be connected to another switch from one side and to hosts from another side.Is there a way to configure the switch in case the link between the two switches is down bring all the ports connected...

Has anyone had an issue with sporatic ports working and not working on code s72033-ipservicesk9-vz.122-33.SXH2a.bin? What is the most stable ip services code currently for the 6513 sup720? We tested the cables and they are good.

What could be the cause of this problem:EVENT ID = 0000A18ALERT ID = 000014ITIME = Tue 05-Aug-2008 05:26:34 MSDSTATUS = ActiveSEVERITY = CriticalMANAGED OBJECT ...

Hi there,I have a port on a Cat 6509 in mode trunk :Interface Gigabit1/1 switchport switchport mode trunk switchport trunk allowed vlan 10,20!Is it possible for me to rewrte theese tags (10,20) to 11 and 21, so that I can have vlan interface for each...