Switching

Hello,When I type this command in by using hyperterminal I get the Ip address of 1. Can anyone explain to me why? I am new in the cisco world and could use your help.Thanks,Lon

We have an environmet with a 6509 in top whitch is the root for the stp and 150 operational VLAN's. We applied vtp pruning to the domain but we did not get results.All the VLAN's are in the non pruning state at trunks.Has anyone had the same problemI...

hi can someone tell me how to install a static route based on certain condition ? and remove it if that condition is no more met ? i know that there is a way of doing it but i m not able to remember how so some one help me out on thisthanks

Hi,I would like to upgrade my Cisco 6509 catalyst switch?s CMM module IOS with new image. I need all steps how to upgrade the IOS with commands. RegardsKishore.

Dear AllI have a problem on two 16 GIGA ethernet modules on 6500 swithch, the servers connected on these modules couldnt see each other and they on the same vlan, when i put the servers on the same module they see each other.IOS 12.2(18)zxd6thank you...

i read this in some book:i have ip addrees 172.31.128.255/18 and it says that its unicast address!how can that be? it says also that its broadcast address is 172.31.131.255.from my calculations the broadcast is 172.31.191.255 and in the address172.31...

Hi All, Could someone be kind to help me with the Lower half subnet address of 192.168.3.2/24?Urgent assistance shall be appreciated,Regards,NewNetMan

hello dear guysi have a 2811 with secure iosi want to create a pptp tunnel from my cisco router to my isa serverhelp this way please

I want to give access to a few commands like Shut, no shut on an interface of router to an exec level other than 15. How to do it?

I have a 3550 I am trying to configure OSPF and get :Unknown routing protocol"Ususally means the image does not support ospf.Do I need an image upgrade?Cisco Internetwork Operating System SoftwareIOS (tm) C3550 Software (C3550-I9Q3L2-M), Version 12.1...

Can cisco 3750 just die out after use in a week what is teh cuse of just the fan blowing and no display coming fo rthe switch ports

I have using Cisco 3560 catalyst switchwith IOS Release 12.2(25)SEB4. But the problem is that the switch does not supportservice-policy output to restrict egress bandwidth in an interface as we can do in Cisco 3550 switch.Any workout in this problem....

I passed the CCNA 640-801 exam this morning and i have got 1000 , what i want to say is thanx for every person encourage , support , help me in preparing for the exam and passing especially my friend,teacher, mentor who is Mohammad Moustafa.BR,Ibrahi...