Switching

Discuss Catalyst brand switches with peers and experts.
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

Labels

Forum Posts

I can't seem to figure this out. I'm hoping someone can help me out. We have two 3560 series switches (we'll call them A & B). VLAN 5 traffic is spread accross both switches. I want to monitor all VLAN 5 traffic to port 24 of switch A. If I do thi...

ddcarlson by Level 1
  • 586 Views
  • 3 replies
  • 0 Helpful votes

Hi,I have a Catalyst 4006 with Supervisor 2 WS-X4013+I want to create more than 200 VLANs on the switch, with as many STP instance. Is it possible with this Supervisor Card?ThanksRegardsCisco Internetwork Operating System Software IOS (tm) Catalyst 4...

rdubo by Level 1
  • 519 Views
  • 1 replies
  • 0 Helpful votes

Hi have a loan 4506 and its in a small cabinet acting as a access switch. the temp of the unit is from 40 - 43 i feel in the summer this could rise a lot higher. I know the recommend temp of threshold is 75 degrees but has anyone had any experence if...

Hi,I was wondering if Cisco IOS can act as a DNS Server. Can IOS provide basic DNS services or provide DNS forwarding?I know IOS can provide DHCP services. Can IOS provide basic DNS services as well?Any help or insight would be appreciated.Thank yo...

I have 2 hp c-Class enclosures..each have 2 cisco 3020s...so 4 total. these 4 switches connect back to 2 6513s. I am trunking between the 3020s and 6513s...however I am seeing something weird. On the 3020s, I am seeing the interfaces as up and on ...

joebenz by Level 1
  • 695 Views
  • 4 replies
  • 0 Helpful votes

I'm trying to connect port 23 and 24 as interconnect port in C-Class bay1 and bay2. From the documention it says I ned to use interface command media-type internal but in my case I'm not able top bring interface 23 and 24 up. Have anyone seen this be...

nawas by Level 4
  • 638 Views
  • 1 replies
  • 0 Helpful votes

Hello all.I have a WS-C2924-XL, and have noticed a lot of up / down on port 17. I this normal behavior or something else I should be concerned about?Attached are the log and config.ThanxSteve

Hi,I have just figured out that the "CISCO-STACK-MIB" was not supported by the Cat4K IOS, is that possible to confirm me this ?As a result, how can I monitor the status of my standby sup on a Cisco 4500 ?Thanks.Best regards,Romain

My 6506 sup1a with MSFC goes into Route Processor Ronmon. I believe the MSFC boot image is corrupt while updating.Trying to use the xmodem -s9600 -c and transfer the 1.8 meg file using the console port. It starts tranferring then hangs, i am using hy...

HI Gents,I have configured BGP with ISP like this.neighbor 10.10.1.1 remote-as 65000neighbor 10.10.1.1 activateneighbor 10.10.1.1 soft-reconfiguration inboundneighbor 10.10.1.1 prefix-list TEST-PREFIX outno auto-summaryno synchronizationnetwork 20.20...