Switching

HiWe recently built a new VXLAN topology in our datacenter which is pretty much like a Leaf-and-Spine. Strange issues happen during our laboratory testing and that's why I decided to explain what we did. Hope somebody here may have some clue as for w...

    After switch bootup ZTP is not getting started.  I have below ISC-DHCP Settings and ZTP-poap config file. I am not seeing the guestshell  getting started during ZTP. Anyone faced similar situation.      Installed CAT3K_CAA-UNIVERSALK9-M Version 1...

Hi All!  I recently purchased a Cisco 3750x from ebay to replace my dead Cisco 2960G switch.  After resetting the switch to factory default settings and some basic configuration, I'm only able to receive no more than 300/300 with a 1000/1000 AT&T Fib...

I have systems in VLAN10 and VLAN20 which can talk inside their networks, but not to each other which is how I want, but I have a server (10.10.30.100) which I need all machines, on both VLANs, to be able to access as it'll be a kind of DNS server. I...

Hello,I have a switch stack 3750E which is VTP server and there are other switches connected from this stack. Other switches are VTP client but one of them is on the different domain than the VTP server. That switch has VLAN configured but I wanted t...

Hello! Have a problem with one project. We need to use SFP module GLC-FE-100LX with WS-C2960X-24TS-L communicator. But, as I know, in SFP compatibility table we don't have matches between WS-C2960X-24TS-L and GLC-FE-100LX. Anyway, is it possible to u...

We have some serious problems with Cisco branded SFPs GLC-T not locking in the slots of the module N55-M16UP in a Nexus 5548. The SFPs are just sliding out and is not locking inside the slot, is this a general problem with the module, anyone else had...

What is vx sensor on Catalyst 9400 bellow. 9410R#sh environmentNumber of Critical alarms: 0Number of Major alarms: 0Number of Minor alarms: 0Slot Sensor Current State Reading Threshold(Minor,Major,Critical,Shutdown)---------- -------------- ---------...

I'm trying to plan for a server that will be running 4 VMs. While I was contemplating the way I would have it work, I realized I needed each VM to be on a different VLAN. From what I understand, I could set up the port it's attached to on the switch ...

Hi, I am fairly new at configuring networks. I have been trying to get this network design to work in packet tracer and I can not for some reason figure out where I went wrong. I am mostly working on the areas with the two core switches. I can ping u...

I was after OID for individual cores for cisco 3850 so we can monitor each core usage.

Hi.The switch is a 3750 and I have issued a "no ip routing" command. I'm using an OpenBSD 6.6 machine for intervlan routing and I'm trying to rule out if my problem is in the 3750's configuration or in OpenBSD's. spanning-tree mode pvst spanning-tree...