Switching

Right now I have 2 default routes load balancing 100MB internet links.  This is on my 2 6509's.ip route 0.0.0.0 0.0.0.0 10.47.2.1 (FWSM)ip route 0.0.0.0 0.0.0.0 10.47.2.250 (5510)Is there anyway to make the first default route take more of the traffi...

I know this is going to sound rediculous but I need a second opinion.  I have a Cat6506.  There were 2 Sup 720 in it for redundancy.  They told me they had problems with this thing in the past needing to go out and reboot the machine.  I need to go o...

please find the output of the show commands below.Before resetting the port-security  on the interface  --UNB-Deira-Br-2950SW2# sh mac-address-table | i   0/7   1    0007.3be4.0171     STATIC      Fa0/7117    0007.3be4.0171    STATIC       Fa0/7Same ...

hi all,I used Cisco ME 3400E Series with 12 dual-purpose (10/100/1000 and Small Form-Factor Pluggable [SFP]) ports, four SFP uplinks. Could I plug other vendor SFP into Cisco ME 3400?Thx,Dn Quynh

Hi, new storage offers the following enhancements; Priority-based Flow Control (PFC), Enhanced Transmission Selection (ETS), Datacenter Bridging Capability Exchange (DCB) and Congestion Notification (CN)Does the 4507 support these features?CheersBren...

Hey guys, sorry I'm an Cisco newbie. I configured this router based on random articles I found on the internet. Not suprisingly it didnt work when I connected it, I was able to get CCP connected and I tried disabling the firewall functions (wasnt sur...

Hello Everyone,I want to know if there is way to tag traffic with DCSP tags without having to do all the other requirments of QOS setup.  All i want to do is just tag traffic at different DCSP values via source and destination IPs.  We do not have a ...

Good day,I would appreciate help on how to build up the components of the 4507 switch. Yes I know about the cisco configuration tool but i am not too sure about each component eg to go with the 2800W power or 1400W, does the IOS come preinstalled or ...

All:Looking into a strange  issue; not sure if any of you have seen this before.  Basically, no snmp trap is sent for a violation of  shutdown.  SNMP traps with violation of restrict is sent just fine.   Thought this was interesting.  On a 6509 the S...

Hi, i dont have two Layer 3 switches to test it out myself, i am not sure if it work or not. can someone confirm in light of experience/knowledge if it will or not.I have a Layer 3Switch with VTP Domain ABC and 3 vlans gateway on it , a Tail T-switch...

I am using a 3750 as a default gateway for multiple Vlans on a few 2960 switches. The trunk lines are configured and working and I have assigned ip addresses to each of the Vlan interfaces on the 3750. My issue is that I can only ping the ip address ...

Greetings,Right now I'm developing a project where I use the SNMP protocol to discover the network. By discovering the network I mean go through all the routers and switches and retrieve the IP routing table from routers and the forwarding table from...

I have two Motorola MC9090's that will no longer connect through my MPLS back to coperate.  They both stopped working at the exact same time yesterday.They connect to a Cisco WAP321 that is connected to a Catylist 3750 that is connected to a Cisco 19...