Thanks - that was a cable inside the unit that was removed as we thought it might be an issue, works on the 2960X now so I have it all linked up in the 9200 which is showing the following:
###################### It's on a patchlead (2m) #########################################
Interface Speed Local pair Pair length Remote pair Pair status
--------- ----- ---------- ------------------ ----------- --------------------
Gi1/0/8 100M Pair A 0 +/- 10 meters N/A Normal
Pair B 110 +/- 5 meters N/A Short/Crosstalk
Pair C 1 +/- 5 meters N/A Short
Pair D 1 +/- 5 meters N/A Short
interface GigabitEthernet1/0/8
description ### Door Access ###
switchport access vlan 70
switchport mode access
power inline port 2x-mode
power inline port 2-event
power inline static
speed 100
duplex full
no cdp enable
no snmp trap link-status
spanning-tree portfast
end
GigabitEthernet1/0/8 is down, line protocol is down (notconnect)
Hardware is Gigabit Ethernet, address is c064.e4a1.4688 (bia c064.e4a1.4688)
Description: ### Door Access ###
MTU 1500 bytes, BW 1000000 Kbit/sec, DLY 10 usec,
reliability 255/255, txload 1/255, rxload 1/255
Encapsulation ARPA, loopback not set
Keepalive set (10 sec)
Full-duplex, 100Mb/s, media type is 10/100/1000BaseTX
input flow-control is on, output flow-control is unsupported
ARP type: ARPA, ARP Timeout 04:00:00
Last input 5d19h, output 5d19h, output hang never
Last clearing of "show interface" counters never
Input queue: 0/2000/0/0 (size/max/drops/flushes); Total output drops: 0
Queueing strategy: fifo
Output queue: 0/40 (size/max)
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
27 packets input, 3309 bytes, 0 no buffer
Received 27 broadcasts (9 multicasts)
0 runts, 0 giants, 0 throttles
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored
0 watchdog, 9 multicast, 0 pause input
0 input packets with dribble condition detected
10 packets output, 1912 bytes, 0 underruns
0 output errors, 0 collisions, 25 interface resets
0 unknown protocol drops
0 babbles, 0 late collision, 0 deferred
0 lost carrier, 0 no carrier, 0 pause output
0 output buffer failures, 0 output buffers swapped out
LBASW01#sho power inli
Module Available Used Remaining
(Watts) (Watts) (Watts)
------ --------- -------- ---------
1 819.0 90.2 728.8
Interface Admin Oper Power Device Class Max
(Watts)
--------- ------ ---------- ------- ------------------- ----- ----
Gi1/0/8 static on 30.0 Ieee PD 4 30.0
