06-30-2021 06:08 AM
Hello,
2 nexus 3k in VPC configuration.
Someone can explain why non-Cisco Transcivers are sometimes accepted and sometimes rejected as "not supported"?
And I'm talking about the exact same Transceiver model (HP): 2 or 3 of them do work, others don't
Here's what works:
06-30-2021 06:15 AM - edited 06-30-2021 06:16 AM
depends on version code, but most does with below command :
Nexus(config)# Inter e1/35
Nexus(config-if)# service unsupported-transceiver
Also if this is 10GB ports, some time setting up the speed also helps
Note : Cisco TAC do not support if any issue related the interface issue.
06-30-2021 06:15 AM
@Claudio Battan : Can you share the part code number of the Transreceiver you are using. Most of the time it's detectable but not supported.
Regards
Inderdeep Singh
www.thenetworkdna.com ( Awarded by Cisco IT Blogs award 2020)
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide