06-30-2021 06:08 AM
Hello,
2 nexus 3k in VPC configuration.
Someone can explain why non-Cisco Transcivers are sometimes accepted and sometimes rejected as "not supported"?
And I'm talking about the exact same Transceiver model (HP): 2 or 3 of them do work, others don't
Here's what works:
06-30-2021 06:15 AM - edited 06-30-2021 06:16 AM
depends on version code, but most does with below command :
Nexus(config)# Inter e1/35
Nexus(config-if)# service unsupported-transceiver
Also if this is 10GB ports, some time setting up the speed also helps
Note : Cisco TAC do not support if any issue related the interface issue.
06-30-2021 06:15 AM
@Claudio Battan : Can you share the part code number of the Transreceiver you are using. Most of the time it's detectable but not supported.
Regards
Inderdeep Singh
www.thenetworkdna.com ( Awarded by Cisco IT Blogs award 2020)
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: