01-18-2019 01:20 PM - edited 03-08-2019 05:04 PM
I am using a router as ntp server (it is master).
And other devices on the network are configured as slave.
When I run the show ntp status command, I check that the slave is not configured with the master address.
Can someone help me ?
To be more enlightening I send a print-screen.
01-18-2019 01:43 PM
Hello
Is the ntp server reachable?
any access-list negating ip or port communication?
any ntp authentication applied such a authentication/trusted key
01-18-2019 02:28 PM
01-19-2019 07:16 AM
Can you post the configuration and show ntp status
01-19-2019 07:35 AM
01-19-2019 08:58 AM
Can you post the config of the device that you are using as master and the config of the slave device? Can you confirm that the slave device does have IP connectivity to the master?
HTH
Rick
01-21-2019 12:36 AM
Hi,
Please share the NTP configuration
show run | sec ntp
show ntp associations
BR
Tayyab
01-21-2019 12:45 AM
Hello,
on a side note, in addition to the other posts, it can help if you manually set the clock to something close to the real time on the NTP server (using the 'clock set' exec command), usually your device will sync with the server after a few minutes then...
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide