01-27-2009 11:39 PM - edited 03-06-2019 03:42 AM
Hi, I have a network of 3 switches given in the diagram. I can ping any Ip from 2960_1 but I cannot ping even gateway from 2960_2. Can you tell me the problem. But can pingable any IPS from the Laptop connected that switch
01-28-2009 12:46 AM
The Link between C2960-1 and C2960-2 should be a Trunk link.
HTH
Mohamed
01-28-2009 01:15 AM
yes I have reconfigured as a trunk but still I cannot ping any ips from the switch. but I can ping from that Laptop.
01-28-2009 04:47 AM
Goutam,
Do you have any IP address assigned on 2960_2. If yes, then what and on which interface / SVI?
Regards
Vaibhav
01-28-2009 08:38 PM
No, only one loopback Interface configured. But in 2960_1 there is no IP configured except one Management Vlan with Management IP. That mean do I need to configure the Vlan 800 with IP address in 2960_2 Switch?
01-28-2009 09:10 PM
yes
01-28-2009 05:27 AM
How are you going to ping anything if switch 2 doesn't have an ip address on it ?
01-29-2009 02:38 AM
Just as a tip, you can create the diagram in Visio then save it as a picture/jpg file.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide