01-31-2012 07:25 AM - edited 03-17-2019 10:46 PM
Hi everybody !
I have some problem with Tandberg 990 MXP TTC7-08, I’m trying to reset this device, but I don’t know how to do this with remote control.
Can someone help me ?
Solved! Go to Solution.
01-31-2012 10:46 PM
Hi,
With the DVI output of the codec connected to your display, try the following :
a) Press ‘Phonebook’ button 5 times (audible tone will be heard)
b) Press the number ‘2’ key
see if you get the menu back
Regards,
Tang
=====
01-31-2012 11:42 AM
The MXP Administrator Guide (T9) covers this on page 19.
Please rate helpful responses.
01-31-2012 07:08 PM
My Tandberg didn't show me any settings menu
01-31-2012 07:18 PM
Is you dispaly DVI or Svideo connected to the codec ?
If its DVI then it may be the unit is configred for dual monitors and Menu on PC setting is set to off.
If you are S video connected, then try the DVI if you dont get a menu on either you will need to factory default via serial or web if you know the IP address and password
When you factory defaulty it cna remove the option keys so take a recordof them before you factory default.
01-31-2012 10:46 PM
Hi,
With the DVI output of the codec connected to your display, try the following :
a) Press ‘Phonebook’ button 5 times (audible tone will be heard)
b) Press the number ‘2’ key
see if you get the menu back
Regards,
Tang
=====
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide