cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
8588
Views
30
Helpful
8
Replies

SIP Options Ping and session server-group on dial-peer

aalejo
Level 5
Level 5

Hi

Does someone have configured SIP options ping on a dial-peer that uses session server-group?

How server keep track of each individual ip address on the server-group on the dial peer?

In Brief, these two commands on the dial peer:

session server-group <group number>

voice class sip options ping

-Alex

1 Accepted Solution

Accepted Solutions

Anthony Holloway
Cisco Employee
Cisco Employee

Here's what works for me.

I create a server group class

voice class server-group 1
ipv4 1.1.1.1 preference 1
ipv4 2.2.2.2 preference 2
!

I then create an empty sip options class

voice class sip-options-keepalive 1
description Server Group SIP OPTIONS PING (Intentionally Left Blank)
!

Finally, I apply the server group and options classes to my dial-peer

dial-peer voice 1 voip
session server-group 1
voice-class sip options-keepalive profile 1
...other dial-peer commands here...
!

You can use the following command to view the status of the dial-peer as a whole

show dial-peer voice summary

You can use the following command to view the status of each server in the server group

show voice class sip-options-keepalive 1

View solution in original post

8 Replies 8

Adarsh Chauhan
Level 3
Level 3

Hi,

Please refer to:

http://www.cisco.com/c/en/us/td/docs/ios/voice/cube/configuration/guide/vb_book/vb_book/vb_9321.html

Please rate and mark correct if helpful

Regards,

Adarsh Chauhan


Please rate and mark correct if helpful
Regards,
Adarsh Chauhan

Hi Adarsh

That's the configuration i use but that's when you use a dial-peer session pointing to a single endpoint and not a server group.

Alex

Anthony Holloway
Cisco Employee
Cisco Employee

Here's what works for me.

I create a server group class

voice class server-group 1
ipv4 1.1.1.1 preference 1
ipv4 2.2.2.2 preference 2
!

I then create an empty sip options class

voice class sip-options-keepalive 1
description Server Group SIP OPTIONS PING (Intentionally Left Blank)
!

Finally, I apply the server group and options classes to my dial-peer

dial-peer voice 1 voip
session server-group 1
voice-class sip options-keepalive profile 1
...other dial-peer commands here...
!

You can use the following command to view the status of the dial-peer as a whole

show dial-peer voice summary

You can use the following command to view the status of each server in the server group

show voice class sip-options-keepalive 1

Hello Anthony,

 

Do you need to have enabled the Ping Options on the SIP profile of the SIP trunk, if the other side of the dial peer is a CUCM ?

Thanks in advance,

George

Please Rate Posts (by clicking on Star) and/or Mark Solutions as Accepted, when applies

No, you do not. They are separate.

Thanks for the feedback, I ‘ll give it a try

Please Rate Posts (by clicking on Star) and/or Mark Solutions as Accepted, when applies

Curious if this ended up working for you. Going through something similar as well, and unsure if I need to creat a SIP profile to insert into the voice class options ping.

 

Thanks

Thanks Anthony, great post!