Hello,
I need an urgent help from you guys. We need to connect with another company via TP whose endpoint SIP URI is extension@x.x.x.x(ip address).
We have CUCM, expressway C & E. all connected and working fine. We are able to dial via domains but ...
Hi Folks,I am researching what we need and how we integrate (on-prem) video-conferencing into our existing CUCM infrastructure. We are currently using CUCM v11.5(1) and run Expressway E & C for our mobile Jabber clients. We also have a mix of on-Prem...
I have what should be a simple question, but has seemed to confound the Cisco help desk folks. I want to know if it possible to save a contacts IP address or IP alias along with a pin that is needed for a recurring meeting. I want to do this on an SX...
Hi, Just need some clarification. Do we need separate server certificates for the core (callbridge, xmpp, trunk) and edge (webbridge, load balancer, TURN)?Also within a cluster does all the cores (callbridge, xmpp, trunk) need their own server cert o...
Hi AllQuick question, if I upgrade the device pack for vc devices on my CUCM, will this upgrade the software on the VC devices, OR can you only do this from the device itself or TMS?Cheers
Running VCSC x8.8.2I plan to upgrade to 12.5.6 and need to know if I can run the 12.5.6 upgrade file directly or do I have to increment from x8.8.2 and if so what firmware version should I use ??? Also on another note I have an old VCSC running x8....
Running Codian 4320's. Getting tons of the following warnings ... Can't find where to clear them ... CPU's running over 50 percent and most of the time the bridge is sitting idle ???Network Warning getsockname () failed: Invalid...
Running CMS 2.6.1 Was working fine 5 day ago... Nothing noticeable changed but now when I try to login via the admin interface using any browser I get the reconnecting circle ?? Also I can't dial into any of my co spaces. I have rebooted the cms twi...
The customer have old MCU server Tabndberg MPS200 with latest on current day firmware. This MCU can work with maximum 4CIF resolution. When he start the meeting, Room Kit send to MCU the 4CIF resolution but MCU send to Room Kit only the CIF resolutio...
We have a C90 running firmware version TC7.3.2.14ad7cc.On our older 6000MXP Units there is an option in permissions to set "Allow Incoming Audio Only Calls" to "Off". I would like to do so with our C90 has started to get random robo h.323 calls.We do...
Hi Group, Looking to set up DHCP Snooping and Dynamic ARP Inspection in our network for some added L2 security. Added a few VLANs last night and noticed, after bouncing the ports, the Room Kits on one VLAN I added, were not able to bind address to ...
Hi, I'd like to know about webex meeting number.Sorry if this shoud be another board. I know there are several ways to make a webex meeting call, like call for "{username}@{sitename}.webex.com" or 9-digit meeting number.That {username} I wrote above ...
